| # ADT7420 temperature sensor configuration options |
| |
| # Copyright (c) 2018 Analog Devices Inc. |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| menuconfig ADT7420 |
| bool "ADT7420 Temperature Sensor" |
| default y |
| depends on DT_HAS_ADI_ADT7420_ENABLED |
| select I2C |
| help |
| Enable the driver for Analog Devices ADT7420 High-Accuracy |
| 16-bit Digital I2C Temperature Sensors. |
| |
| if ADT7420 |
| |
| config ADT7420_TEMP_HYST |
| int "Temperature hysteresis in °C" |
| range 0 15 |
| default 5 |
| help |
| Specify the temperature hysteresis in °C for the THIGH, TLOW, |
| and TCRIT temperature limits. |
| |
| config ADT7420_TEMP_CRIT |
| int "Critical overtemperature in °C" |
| range -40 150 |
| default 147 |
| help |
| The critical overtemperature pin asserts when the temperature |
| exceeds this value. The default value of 147 is the reset default |
| of the ADT7420. |
| |
| choice |
| prompt "Trigger mode" |
| default ADT7420_TRIGGER_NONE |
| help |
| Specify the type of triggering used by the driver. |
| |
| config ADT7420_TRIGGER_NONE |
| bool "No trigger" |
| |
| config ADT7420_TRIGGER_GLOBAL_THREAD |
| bool "Use global thread" |
| depends on GPIO |
| depends on $(dt_compat_any_has_prop,$(DT_COMPAT_ADI_ADT7420),int-gpios) |
| select ADT7420_TRIGGER |
| |
| config ADT7420_TRIGGER_OWN_THREAD |
| bool "Use own thread" |
| depends on GPIO |
| depends on $(dt_compat_any_has_prop,$(DT_COMPAT_ADI_ADT7420),int-gpios) |
| select ADT7420_TRIGGER |
| |
| endchoice |
| |
| config ADT7420_TRIGGER |
| bool |
| |
| config ADT7420_THREAD_PRIORITY |
| int "Thread priority" |
| depends on ADT7420_TRIGGER_OWN_THREAD && ADT7420_TRIGGER |
| default 10 |
| help |
| Priority of thread used by the driver to handle interrupts. |
| |
| config ADT7420_THREAD_STACK_SIZE |
| int "Thread stack size" |
| depends on ADT7420_TRIGGER_OWN_THREAD && ADT7420_TRIGGER |
| default 1024 |
| help |
| Stack size of thread used by the driver to handle interrupts. |
| |
| endif # ADT7420 |
