| # Copyright (c) 2023 PHOENIX CONTACT Electronics GmbH |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| description: | |
| ADIN2111 standalone 10BASE-T1L Ethernet controller with SPI interface. |
| |
| An example: |
| |
| adin2111: adin2111@0 { |
| compatible = "adi,adin2111"; |
| reg = <0x0>; |
| spi-max-frequency = <25000000>; |
| int-gpios = <&gpioe 12 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>; |
| reset-gpios = <&gpioe 8 GPIO_ACTIVE_LOW>; |
| port1 { |
| local-mac-address = [ CA 2F B7 10 23 63 ]; |
| }; |
| port2 { |
| local-mac-address = [ 3C 82 D4 A2 29 8E ]; |
| }; |
| mdio: mdio { |
| compatible = "adi,adin2111-mdio"; |
| status = "okay"; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| phy@1 { |
| reg = <0x1>; |
| compatible = "adi,adin2111-phy"; |
| status = "okay"; |
| }; |
| phy@2 { |
| reg = <0x2>; |
| compatible = "adi,adin2111-phy"; |
| status = "okay"; |
| }; |
| }; |
| }; |
| |
| compatible: "adi,adin2111" |
| |
| include: [spi-device.yaml] |
| |
| bus: adin2111 |
| |
| properties: |
| int-gpios: |
| type: phandle-array |
| required: true |
| description: | |
| The interrupt pin of ADIN2111 is active low. |
| If connected directly the MCU pin should be configured |
| as active low. |
| reset-gpios: |
| type: phandle-array |
| description: The reset pin of ADIN2111. |
| |
| child-binding: |
| description: Port properties |
| properties: |
| local-mac-address: |
| type: uint8-array |
| description: | |
| Specifies the MAC address that was assigned to the network device. |
