| CONFIG_ARM=y |
| CONFIG_BOARD_STM32_MINI_A15=y |
| CONFIG_SOC_FAMILY_STM32=y |
| CONFIG_SOC_SERIES_STM32F1X=y |
| CONFIG_SOC_STM32F103XE=y |
| CONFIG_CORTEX_M_SYSTICK=y |
| # 72MHz system clock |
| CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=72000000 |
| |
| # enable uart driver |
| CONFIG_SERIAL=y |
| CONFIG_UART_STM32=y |
| CONFIG_UART_STM32_PORT_1=y |
| |
| # enable pinmux |
| CONFIG_PINMUX=y |
| CONFIG_PINMUX_STM32=y |
| |
| # enable GPIOs |
| CONFIG_GPIO=y |
| CONFIG_GPIO_STM32=y |
| CONFIG_GPIO_STM32_PORTB=y |
| |
| # clock configuration |
| CONFIG_CLOCK_CONTROL=y |
| # Clock configuration for Cube Clock control driver |
| CONFIG_CLOCK_STM32_HSE_CLOCK=8000000 |
| CONFIG_CLOCK_STM32_SYSCLK_SRC_PLL=y |
| # use HSE as PLL input |
| CONFIG_CLOCK_STM32F_PLL_SRC_HSE=y |
| # produce 72MHz clock at PLL output |
| CONFIG_CLOCK_STM32_PLL_XTPRE=n |
| CONFIG_CLOCK_STM32_PLL_MULTIPLIER=9 |
| CONFIG_CLOCK_STM32_AHB_PRESCALER=1 |
| # APB1 clock must not to exceed 36MHz limit |
| CONFIG_CLOCK_STM32_APB1_PRESCALER=2 |
| CONFIG_CLOCK_STM32_APB2_PRESCALER=1 |
| |
| # console |
| CONFIG_CONSOLE=y |
| CONFIG_UART_CONSOLE=y |
