| source [find interface/stlink-dap.cfg] |
| |
| set WORKAREASIZE 0x8000 |
| |
| transport select "dapdirect_swd" |
| |
| set CHIPNAME STM32U575ZITxQ |
| set BOARDNAME NUCLEO-U575ZI-Q |
| |
| # Enable debug when in low power modes |
| set ENABLE_LOW_POWER 1 |
| |
| # Stop Watchdog counters when halt |
| set STOP_WATCHDOG 1 |
| |
| # STlink Debug clock frequency |
| set CLOCK_FREQ 8000 |
| |
| # Reset configuration |
| # use hardware reset, connect under reset |
| # connect_assert_srst needed if low power mode application running (WFI...) |
| reset_config srst_only srst_nogate connect_assert_srst |
| set CONNECT_UNDER_RESET 1 |
| set CORE_RESET 0 |
| |
| # ACCESS PORT NUMBER |
| set AP_NUM 0 |
| # GDB PORT |
| set GDB_PORT 3333 |
| |
| # BCTM CPU variables |
| |
| source [find target/stm32u5x.cfg] |
| |
| $_TARGETNAME configure -event gdb-attach { |
| echo "Debugger attaching: halting execution" |
| reset halt |
| gdb_breakpoint_override hard |
| } |
| |
| $_TARGETNAME configure -event gdb-detach { |
| echo "Debugger detaching: resuming execution" |
| resume |
| } |