soc/arm/st_stm32/common/soc_config.c

/*
 * Copyright (c) 2021 Andrés Manelli <am@toroid.io>
 *
 * SPDX-License-Identifier: Apache-2.0
 */

/** @file
 * @brief System module to support early STM32 MCU configuration
 */

#include <zephyr/device.h>
#include <zephyr/init.h>
#include <soc.h>
#include <zephyr/arch/cpu.h>
#include <stm32_ll_system.h>
#include <stm32_ll_bus.h>

/**
 * @brief Perform SoC configuration at boot.
 *
 * This should be run early during the boot process but after basic hardware
 * initialization is done.
 *
 * @return 0
 */
static int st_stm32_common_config(const struct device *dev)
{
#ifdef CONFIG_LOG_BACKEND_SWO
	/* Enable SWO trace asynchronous mode */
#if defined(CONFIG_SOC_SERIES_STM32WBX)
	LL_DBGMCU_EnableTraceClock();
#else
	LL_DBGMCU_SetTracePinAssignment(LL_DBGMCU_TRACE_ASYNCH);
#endif
#endif /* CONFIG_LOG_BACKEND_SWO */

#if defined(CONFIG_USE_SEGGER_RTT)
	/* On some STM32 boards, for unclear reason,
	 * RTT feature is working with realtime update only when
	 *   - one of the DMA is clocked.
	 * See https://github.com/zephyrproject-rtos/zephyr/issues/34324
	 */
#if defined(__HAL_RCC_DMA1_CLK_ENABLE)
	__HAL_RCC_DMA1_CLK_ENABLE();
#endif /* __HAL_RCC_DMA1_CLK_ENABLE */

	/* On some STM32 boards, for unclear reason,
	 * RTT feature is working with realtime update only when
	 *   - one of the DBGMCU bit STOP/STANDBY/SLEEP is set
	 * See https://github.com/zephyrproject-rtos/zephyr/issues/34324
	 */
#if defined(LL_APB1_GRP1_PERIPH_DBGMCU)
	LL_APB1_GRP1_EnableClock(LL_APB1_GRP1_PERIPH_DBGMCU);
#elif defined(LL_APB1_GRP2_PERIPH_DBGMCU)
	LL_APB1_GRP2_EnableClock(LL_APB1_GRP2_PERIPH_DBGMCU);
#elif defined(LL_APB2_GRP1_PERIPH_DBGMCU)
	LL_APB2_GRP1_EnableClock(LL_APB2_GRP1_PERIPH_DBGMCU);
#endif /* LL_APB1_GRP1_PERIPH_DBGMCU */

#if defined(CONFIG_SOC_SERIES_STM32H7X) || defined(CONFIG_SOC_SERIES_STM32MP1X)
	HAL_EnableDBGSleepMode();
#else
	LL_DBGMCU_EnableDBGStopMode();
#endif /* CONFIG_SOC_SERIES_STM32H7X || CONFIG_SOC_SERIES_STM32MP1X */

#endif /* CONFIG_USE_SEGGER_RTT */

	return 0;
}

SYS_INIT(st_stm32_common_config, PRE_KERNEL_1, 1);