| # STM32 GPIO configuration |
| |
| # Copyright (c) 2016 Open-RnD Sp. z o.o. |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| menuconfig GPIO_STM32 |
| bool "GPIO Driver for STM32 family of MCUs" |
| depends on SOC_FAMILY_STM32 |
| select HAS_DTS_GPIO |
| help |
| Enable GPIO driver for STM32 line of MCUs |
| |
| if GPIO_STM32 |
| |
| config GPIO_STM32_PORTA |
| bool "Enable GPIO port A support" |
| |
| config GPIO_STM32_PORTB |
| bool "Enable GPIO port B support" |
| |
| config GPIO_STM32_PORTC |
| bool "Enable GPIO port C support" |
| |
| config GPIO_STM32_PORTD |
| bool "Enable GPIO port D support" |
| |
| config GPIO_STM32_PORTE |
| bool "Enable GPIO port E support" |
| |
| config GPIO_STM32_PORTF |
| bool "Enable GPIO port F support" |
| |
| config GPIO_STM32_PORTG |
| bool "Enable GPIO port G support" |
| |
| config GPIO_STM32_PORTH |
| bool "Enable GPIO port H support" |
| |
| config GPIO_STM32_PORTI |
| bool "Enable GPIO port I support" |
| |
| config GPIO_STM32_PORTJ |
| bool "Enable GPIO port J support" |
| |
| config GPIO_STM32_PORTK |
| bool "Enable GPIO port K support" |
| |
| choice GPIO_STM32_SWJ |
| prompt "Serial wire JTAG configuration" |
| depends on SOC_SERIES_STM32F1X |
| |
| config GPIO_STM32_SWJ_ENABLE |
| depends on !(SOC_STM32F103XE && SPI_3) |
| bool "Full SWJ (JTAG-DP + SW-DP): Reset State" |
| |
| config GPIO_STM32_SWJ_NONJTRST |
| depends on !(SOC_STM32F103XE && SPI_3) |
| bool "Full SWJ (JTAG-DP + SW-DP) but without NJTRST" |
| |
| config GPIO_STM32_SWJ_NOJTAG |
| bool "JTAG-DP Disabled and SW-DP Enabled" |
| |
| config GPIO_STM32_SWJ_DISABLE |
| bool "JTAG-DP Disabled and SW-DP Disabled" |
| |
| endchoice |
| |
| endif # GPIO_STM32 |
