| # Distributed Switch Architecture [DSA] device configuration options |
| |
| # Copyright (c) 2020 DENX Software Engineering GmbH |
| # Lukasz Majewski <lukma@denx.de> |
| # Copyright 2025 NXP |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| config ETH_DSA_SUPPORT_DEPRECATED |
| bool |
| help |
| Set by an ethernet driver that supports DSA. This is obsolete, |
| and only used for legacy dsa device. |
| |
| menuconfig DSA_DRIVERS |
| bool "Distributed Switch Architecture device drivers" |
| default y if NET_DSA |
| help |
| Enable Distributed Switch Architecture support. |
| |
| if DSA_DRIVERS |
| |
| config DSA_KSZ8XXX |
| bool |
| |
| config DSA_KSZ8794 |
| bool "Support for KSZ8794" |
| default y |
| depends on DT_HAS_MICROCHIP_KSZ8794_ENABLED |
| select DSA_KSZ8XXX |
| select SPI if $(dt_compat_on_bus,$(DT_COMPAT_MICROCHIP_KSZ8794),spi) |
| help |
| Add support for KSZ8794 DSA device driver. |
| |
| config DSA_KSZ8863 |
| bool "Support for KSZ8863" |
| default y |
| depends on DT_HAS_MICROCHIP_KSZ8863_ENABLED |
| select DSA_KSZ8XXX |
| select SPI if $(dt_compat_on_bus,$(DT_COMPAT_MICROCHIP_KSZ8863),spi) |
| help |
| Add support for KSZ8863 DSA device driver. |
| |
| config DSA_KSZ8463 |
| bool "Support for KSZ8463" |
| default y |
| depends on DT_HAS_MICROCHIP_KSZ8463_ENABLED |
| select DSA_KSZ8XXX |
| select SPI if $(dt_compat_on_bus,$(DT_COMPAT_MICROCHIP_KSZ8463),spi) |
| help |
| Add support for KSZ8463 DSA device driver. |
| |
| config DSA_KSZ_TAIL_TAGGING |
| bool "Support for tail tagging" |
| depends on DSA_KSZ8794 || DSA_KSZ8863 || DSA_KSZ8463 |
| help |
| Add support for tail tagging on DSA device. |
| |
| config DSA_KSZ_PORT_ISOLATING |
| bool "Support for ports isolating" |
| depends on DSA_KSZ8794 || DSA_KSZ8863 || DSA_KSZ8463 |
| help |
| Add support for traffic isolation on DSA slave ports |
| |
| config DSA_SPI |
| bool "Support for PHY SPI interface" |
| depends on SPI && (DSA_KSZ8794 || DSA_KSZ8863 || DSA_KSZ8463) |
| help |
| Use SPI bus to communicate with PHY |
| |
| config DSA_NXP_IMX_NETC |
| bool "Support for NXP i.MX NETC" |
| default y |
| depends on DT_HAS_NXP_NETC_SWITCH_ENABLED |
| help |
| Add support for NXP i.MX NETC DSA device driver. |
| |
| endif # DSA_DRIVERS |
