| .. _npcx7m6fb_evb: |
| |
| NPCX7M6FB_EVB |
| ################### |
| |
| Overview |
| ******** |
| |
| The NPCX7M6FB_EVB kit is a development platform to evaluate the |
| Nuvoton NPCX7 series microcontrollers. This board needs to be mated with |
| part number NPCX796FB. |
| |
| .. image:: ./npcx7m6fb_evb.png |
| :width: 800px |
| :align: center |
| :alt: NPCX7M6FB Evaluation Board |
| |
| Hardware |
| ******** |
| |
| - ARM Cortex-M4F Processor |
| - 256 KB RAM and 64 KB boot ROM |
| - ADC & GPIO headers |
| - UART0 and UART1 |
| - FAN PWM interface |
| - Jtag interface |
| - Intel Modular Embedded Controller Card (MECC) headers |
| |
| Supported Features |
| ================== |
| |
| The following features are supported: |
| |
| +-----------+------------+-------------------------------------+ |
| | Interface | Controller | Driver/Component | |
| +===========+============+=====================================+ |
| | NVIC | on-chip | nested vector interrupt controller | |
| +-----------+------------+-------------------------------------+ |
| | UART | on-chip | serial port-polling; | |
| | | | serial port-interrupt | |
| +-----------+------------+-------------------------------------+ |
| | PINMUX | on-chip | pinmux | |
| +-----------+------------+-------------------------------------+ |
| | GPIO | on-chip | gpio | |
| +-----------+------------+-------------------------------------+ |
| | CLOCK | on-chip | reset and clock control | |
| +-----------+------------+-------------------------------------+ |
| |
| Other hardware features are not currently supported by Zephyr (at the moment) |
| |
| The default configuration can be found in the defconfig file: |
| ``boards/arm/npcx7m6fb_evb/npcx7m6fb_evb_defconfig`` |
| |
| |
| Connections and IOs |
| =================== |
| |
| Nuvoton to provide the schematic for this board. |
| |
| System Clock |
| ============ |
| |
| The NPCX7M6FB MCU is configured to use the 90Mhz internal oscillator with the |
| on-chip PLL to generate a resulting EC clock rate of 15 MHz. See Processor clock |
| control register (chapter 4 in user manual) |
| |
| Serial Port |
| =========== |
| |
| UART1 is configured for serial logs. |
| |
| |
| Programming and Debugging |
| ************************* |
| |
| This board comes with a Cortex ETM port which facilitates tracing and debugging |
| using a single physical connection. In addition, it comes with sockets for |
| JTAG only sessions. |
| |
| Flashing |
| ======== |
| |
| Build application as usual for the ``npcx7m6fb_evb`` board, and flash |
| using Servo V2, μServo, or Servo V4 (CCD). See the |
| `Chromium EC Flashing Documentation`_ for more information. |
| |
| |
| Debugging |
| ========= |
| |
| Use JTAG/SWD with a J-Link |
| |
| References |
| ********** |
| .. target-notes:: |
| |
| .. _Chromium EC Flashing Documentation: |
| https://chromium.googlesource.com/chromiumos/platform/ec#Flashing-via-the-servo-debug-board |
