blob: c65d1d486d1139c565b641cf5f1821d326fb4b61 [file] [log] [blame]
#
# Copyright 2022 NXP
#
# SPDX-License-Identifier: Apache-2.0
#
if(CONFIG_NXP_IMX_RT_BOOT_HEADER)
zephyr_library()
if(NOT (DEFINED CONFIG_BOARD_MIMXRT1160_EVK_CM7)
OR (DEFINED CONFIG_BOARD_MIMXRT1160_EVK_CM4))
message(WARNING "It appears you are using the board definition for "
"the MIMXRT1160-EVK, but targeting a custom board. You may need to "
"update your flash configuration or device configuration data blocks")
endif()
set(RT1160_BOARD_DIR
"${ZEPHYR_HAL_NXP_MODULE_DIR}/mcux/mcux-sdk/boards/evkmimxrt1160")
if(CONFIG_BOOT_FLEXSPI_NOR)
# Include flash configuration block for RT1160 EVK from NXP's HAL.
# This configuration block may need modification if another flash chip is
# used on your custom board. See NXP AN12238 for more information.
zephyr_compile_definitions(XIP_BOOT_HEADER_ENABLE=1)
zephyr_compile_definitions(BOARD_FLASH_SIZE=CONFIG_FLASH_SIZE*1024)
zephyr_library_sources(${RT1160_BOARD_DIR}/xip/evkmimxrt1160_flexspi_nor_config.c)
zephyr_library_include_directories(${RT1160_BOARD_DIR}/xip)
endif()
if(CONFIG_DEVICE_CONFIGURATION_DATA)
# Include device configuration data block for RT1160 EVK from NXP's HAL.
# This configuration block may need modification if another SDRAM chip
# is used on your custom board.
zephyr_compile_definitions(XIP_BOOT_HEADER_DCD_ENABLE=1)
zephyr_library_sources(${RT1160_BOARD_DIR}/dcd.c)
endif()
endif()
if(CONFIG_MCUX_GPT_TIMER)
message(WARNING "You appear to be using the GPT hardware timer. "
"This timer will enable lower power modes, but at the cost of reduced "
"hardware timer resolution")
endif()