| # Copyright Runtime.io 2018. All rights reserved. |
| # Copyright Nordic Semiconductor ASA 2020-2022. All rights reserved. |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| # The Kconfig file is dedicated to UDP transport of MCUmgr |
| # subsystem and provides Kconfig options to control aspects of |
| # the transport. |
| # |
| # Options defined in this file should be prefixed: |
| # MCUMGR_TRANSPORT_UDP_ |
| |
| menuconfig MCUMGR_TRANSPORT_UDP |
| bool "UDP mcumgr SMP transport" |
| depends on NET_UDP |
| select NET_SOCKETS |
| select NET_SOCKETS_POSIX_NAMES if !POSIX_API |
| help |
| Enables handling of SMP commands received over UDP. |
| Will start a thread for listening on the configured UDP port. |
| |
| if MCUMGR_TRANSPORT_UDP |
| |
| config MCUMGR_TRANSPORT_UDP_IPV4 |
| bool "UDP SMP using IPv4" |
| depends on NET_IPV4 |
| default y |
| help |
| Enable SMP UDP using IPv4 addressing. |
| Can be enabled alongside IPv6 addressing. |
| |
| config MCUMGR_TRANSPORT_UDP_IPV6 |
| bool "UDP SMP using IPv6" |
| depends on NET_IPV6 |
| help |
| Enable SMP UDP using IPv6 addressing. |
| Can be enabled alongside IPv4 addressing. |
| |
| config MCUMGR_TRANSPORT_UDP_PORT |
| int "UDP SMP port" |
| default 1337 |
| help |
| UDP port that SMP server will listen for SMP commands on. |
| |
| config MCUMGR_TRANSPORT_UDP_STACK_SIZE |
| int "UDP SMP stack size" |
| default 512 |
| help |
| Stack size of the SMP UDP listening thread |
| |
| config MCUMGR_TRANSPORT_UDP_THREAD_PRIO |
| int "UDP SMP thread priority" |
| default 0 |
| help |
| Scheduling priority of the SMP UDP listening thread. |
| |
| config MCUMGR_TRANSPORT_UDP_MTU |
| int "UDP SMP MTU" |
| default 1500 |
| help |
| Maximum size of SMP frames sent and received over UDP, in bytes. |
| This value must satisfy the following relation: |
| MCUMGR_TRANSPORT_UDP_MTU <= MCUMGR_TRANSPORT_NETBUF_SIZE + SMP msg overhead - address size |
| where address size is determined by IPv4/IPv6 selection. |
| |
| config MCUMGR_TRANSPORT_UDP_AUTOMATIC_INIT |
| bool "UDP SMP autostart/setup" |
| default y |
| help |
| Enable setting up the UDP SMP transport at boot time without needing |
| any code in the application to do this. Will automatically start the |
| UDP SMP service when the network interface is up and disable it when |
| it goes down (at layer 4). |
| |
| endif # MCUMGR_TRANSPORT_UDP |
