| # Copyright (c) 2020 STMicroelectronics |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| properties: |
| drdy-gpios: |
| type: phandle-array |
| required: false |
| description: DRDY pin |
| |
| This pin defaults to active high when produced by the sensor. |
| The property value should ensure the flags properly describe |
| the signal that is presented to the driver. |
| |
| int-pin: |
| type: int |
| required: false |
| default: 1 |
| enum: |
| - 1 # drdy is generated from INT1 |
| - 2 # drdy is generated from INT2 |
| description: Select DRDY pin number (1 or 2). |
| |
| This number represents which of the two interrupt pins |
| (INT1 or INT2) the drdy line is attached to. This property is not |
| mandatory and if not present it defaults to 1 which is the |
| configuration at power-up. |
| |
| range: |
| type: int |
| required: false |
| default: 3 |
| description: Range in g. Default is power-up configuration. |
| enum: |
| - 0 # 500mg (0.015 mg/LSB) |
| - 1 # 3g (0.122 mg/LSB) |
| - 2 # 1g (0.031 mg/LSB) |
| - 3 # 2g (0.061 mg/LSB) |
| |
| odr: |
| type: int |
| required: false |
| default: 0 |
| description: |
| Specify the default accelerometer output data rate expressed in samples per second (Hz). |
| Default is power-up configuration. |
| enum: |
| - 0 # Power-Down |
| - 1 # 12.5Hz |
| - 2 # 26Hz |
| - 3 # 52Hz |
| - 4 # 104Hz |
| - 5 # 208Hz |
| - 6 # 416Hz |
| - 7 # 833Hz |
| - 8 # 1660Hz |
| - 9 # 3330Hz |
| - 10 # 6660Hz |