| # |
| # Copyright (c) 2016 Intel Corporation |
| # |
| # SPDX-License-Identifier: Apache-2.0 |
| # |
| |
| menuconfig HTS221 |
| bool "HTS221 temperature and humidity sensor" |
| depends on I2C |
| help |
| Enable driver for HTS221 I2C-based temperature and humidity sensor. |
| |
| if !HAS_DTS_I2C_DEVICE |
| |
| config HTS221_NAME |
| string "Driver name" |
| default "HTS221" |
| depends on HTS221 |
| help |
| Device name with which the HTS221 sensor is identified. |
| |
| config HTS221_I2C_MASTER_DEV_NAME |
| string "I2C master where HTS221 is connected" |
| depends on HTS221 |
| default "I2C_0" |
| help |
| Specify the device name of the I2C master device to which HTS221 is |
| connected. |
| |
| endif |
| |
| choice HTS221_TRIGGER_MODE |
| prompt "Trigger mode" |
| depends on HTS221 |
| default HTS221_TRIGGER_GLOBAL_THREAD |
| help |
| Specify the type of triggering to be used by the driver. |
| |
| config HTS221_TRIGGER_NONE |
| bool "No trigger" |
| |
| config HTS221_TRIGGER_GLOBAL_THREAD |
| bool "Use global thread" |
| depends on GPIO |
| select HTS221_TRIGGER |
| |
| config HTS221_TRIGGER_OWN_THREAD |
| bool "Use own thread" |
| depends on GPIO |
| select HTS221_TRIGGER |
| |
| endchoice # HTS221_TRIGGER_MODE |
| |
| config HTS221_TRIGGER |
| bool |
| depends on HTS221 |
| |
| config HTS221_GPIO_DEV_NAME |
| string "GPIO device" |
| default "GPIO_0" |
| depends on HTS221 && HTS221_TRIGGER |
| help |
| The device name of the GPIO device to which the HTS221 interrupt pin |
| is connected. |
| |
| config HTS221_GPIO_PIN_NUM |
| int "Interrupt GPIO pin number" |
| default 0 |
| depends on HTS221 && HTS221_TRIGGER |
| help |
| The number of the GPIO on which the interrupt signal from the HTS221 |
| chip will be received. |
| |
| config HTS221_THREAD_PRIORITY |
| int "Thread priority" |
| depends on HTS221 && HTS221_TRIGGER_OWN_THREAD |
| default 10 |
| help |
| Priority of thread used by the driver to handle interrupts. |
| |
| config HTS221_THREAD_STACK_SIZE |
| int "Thread stack size" |
| depends on HTS221 && HTS221_TRIGGER_OWN_THREAD |
| default 1024 |
| help |
| Stack size of thread used by the driver to handle interrupts. |
| |
| config HTS221_ODR |
| string "Output data rate" |
| depends on HTS221 |
| default "1" |
| help |
| Sensor output data rate expressed in samples per second. |
| Data rates supported by the chip are 1, 7 and 12.5. |