| # |
| # Copyright (c) 2014-2015 Wind River Systems, Inc. |
| # Copyright (c) 2016 Intel Corporation |
| # |
| # SPDX-License-Identifier: Apache-2.0 |
| # |
| |
| menuconfig SYS_POWER_MANAGEMENT |
| bool |
| prompt "Power management" |
| default n |
| help |
| This option enables the board to implement extra power management |
| policies whenever the kernel becomes idle. The kernel informs the |
| power management subsystem of the number of ticks until the next kernel |
| timer is due to expire. |
| |
| if SYS_POWER_MANAGEMENT |
| config SYS_POWER_LOW_POWER_STATE |
| bool |
| prompt "Low power state" |
| default n |
| depends on SYS_POWER_LOW_POWER_STATE_SUPPORTED |
| help |
| This option enables the kernel to interface with a power manager |
| application. This permits the system to enter a custom CPU low power |
| state when the kernel becomes idle. The low power state could be any of |
| the CPU low power states supported by the processor. Generally the one |
| saving most power. |
| |
| config SYS_POWER_DEEP_SLEEP |
| bool |
| prompt "Deep sleep state" |
| default n |
| depends on SYS_POWER_DEEP_SLEEP_SUPPORTED |
| help |
| This option enables the kernel to interface with a power manager |
| application. This permits the system to enter a Deep sleep state |
| supported by the SOC where the system clock is turned off while RAM is |
| retained. This state would be entered when the kernel becomes idle for |
| extended periods and would have a high wake latency. Resume would be |
| from the reset vector same as cold boot. The interface allows |
| restoration of states that were saved at the time of suspend. |
| |
| config DEVICE_POWER_MANAGEMENT |
| bool |
| prompt "Device power management" |
| default n |
| help |
| This option enables the device power management interface. The |
| interface consists of hook functions implemented by device drivers |
| that get called by the power manager application when the system |
| is going to suspend state or resuming from suspend state. This allows |
| device drivers to do any necessary power management operations |
| like turning off device clocks and peripherals. The device drivers |
| may also save and restore states in these hook functions. |
| |
| config TICKLESS_IDLE |
| bool |
| prompt "Tickless idle" |
| default y |
| help |
| This option suppresses periodic system clock interrupts whenever the |
| kernel becomes idle. This permits the system to remain in a power |
| saving state for extended periods without having to wake up to |
| service each tick as it occurs. |
| |
| config TICKLESS_IDLE_THRESH |
| int |
| prompt "Tickless idle threshold" |
| default 3 |
| depends on TICKLESS_IDLE |
| help |
| This option enables clock interrupt suppression when the kernel idles |
| for only a short period of time. It specifies the minimum number of |
| ticks that must occur before the next kernel timer expires in order |
| for suppression to happen. |
| |
| config TICKLESS_KERNEL |
| bool |
| prompt "Tickless kernel" |
| default n |
| depends on TICKLESS_IDLE |
| help |
| This option enables a fully event driven kernel. Periodic system |
| clock interrupt generation would be stopped at all times. This option |
| requires Tickless Idle option to be enabled. |
| |
| config TICKLESS_KERNEL_TIME_UNIT_IN_MICRO_SECS |
| int |
| prompt "Tickless kernel time unit in micro seconds" |
| default 1000 |
| depends on TICKLESS_KERNEL |
| help |
| This option makes the system clock and scheduling granularity. |
| The default will be one mili second. This option also determines |
| the time unit passed in functions like _sys_soc_suspend. The |
| value should be determined based what the timer hardware and driver |
| can support. Specifying too small a time unit than what the overall |
| system speed can support would cause scheduling errors. |
| |
| config BUSY_WAIT_USES_ALTERNATE_CLOCK |
| bool |
| prompt "Busy wait uses alternate clock in tickless kernel mode" |
| default n |
| help |
| In tickless kernel mode, the system clock will be stopped when |
| there are no timer events programmed. If the system clock is to |
| be used to keep time e.g. to get a delta of time cycles then it |
| needs to be turned on using provided APIs. Some platforms have |
| alternate clocks which can be used instead. In that case this flag |
| would be set to true. This flag would be checked before turning |
| on the system clock in APIs that do busy wait reading clock |
| cycles. |
| endif |