blob: 366cc1ac012bb4f956a21e4c17fc83637a3c5e4d [file] [log] [blame]
/*
* Copyright (c) 2015 Intel Corporation.
*
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
#include <nanokernel.h>
#include <sys_io.h>
#include <board.h>
#include <init.h>
#include <string.h>
#include <stdio.h>
#include <stdbool.h>
#include "eth_dw_priv.h"
#include <net/ip/net_driver_ethernet.h>
#include <misc/__assert.h>
#include <errno.h>
#ifdef CONFIG_SHARED_IRQ
#include <shared_irq.h>
#endif
#define SYS_LOG_DOMAIN "ETH DW"
#define SYS_LOG_LEVEL CONFIG_SYS_LOG_ETHERNET_LEVEL
#include <misc/sys_log.h>
static inline uint32_t eth_read(uint32_t base_addr, uint32_t offset)
{
return sys_read32(base_addr + offset);
}
static inline void eth_write(uint32_t base_addr, uint32_t offset,
uint32_t val)
{
sys_write32(val, base_addr + offset);
}
static void eth_rx(struct device *port)
{
struct eth_runtime *context = port->driver_data;
struct eth_config *config = port->config->config_info;
uint32_t base_addr = config->base_addr;
struct net_buf *buf;
uint32_t frm_len = 0;
/* Check whether the RX descriptor is still owned by the device. If not,
* process the received frame or an error that may have occurred.
*/
if (context->rx_desc.own == 1) {
SYS_LOG_ERR("Spurious receive interrupt from Ethernet MAC.\n");
return;
}
if (!net_driver_ethernet_is_opened()) {
goto release_desc;
}
if (context->rx_desc.err_summary) {
SYS_LOG_ERR("Error receiving frame: RDES0 = %08x, RDES1 = %08x.\n",
context->rx_desc.rdes0, context->rx_desc.rdes1);
goto release_desc;
}
frm_len = context->rx_desc.frm_len;
if (frm_len > UIP_BUFSIZE) {
SYS_LOG_ERR("Frame too large: %u.\n", frm_len);
goto release_desc;
}
buf = ip_buf_get_reserve_rx(0);
if (buf == NULL) {
SYS_LOG_ERR("Failed to obtain RX buffer.\n");
goto release_desc;
}
memcpy(net_buf_add(buf, frm_len), (void *)context->rx_buf, frm_len);
uip_len(buf) = frm_len;
net_driver_ethernet_recv(buf);
release_desc:
/* Return ownership of the RX descriptor to the device. */
context->rx_desc.own = 1;
/* Request that the device check for an available RX descriptor, since
* ownership of the descriptor was just transferred to the device.
*/
eth_write(base_addr, REG_ADDR_RX_POLL_DEMAND, 1);
}
/* @brief Transmit the current Ethernet frame.
*
* This procedure will block indefinitely until the Ethernet device is
* ready to accept a new outgoing frame. It then copies the current
* Ethernet frame from the global uip_buf buffer to the device DMA
* buffer and signals to the device that a new frame is available to be
* transmitted.
*/
static int eth_tx(struct device *port, struct net_buf *buf)
{
struct eth_runtime *context = port->driver_data;
struct eth_config *config = port->config->config_info;
uint32_t base_addr = config->base_addr;
/* Wait until the TX descriptor is no longer owned by the device. */
while (context->tx_desc.own == 1) {
}
#ifdef CONFIG_ETHERNET_DEBUG
/* Check whether an error occurred transmitting the previous frame. */
if (context->tx_desc.err_summary) {
SYS_LOG_ERR("Error transmitting frame: TDES0 = %08x, TDES1 = %08x.\n",
context->tx_desc.tdes0, context->tx_desc.tdes1);
}
#endif
/* Transmit the next frame. */
if (uip_len(buf) > UIP_BUFSIZE) {
SYS_LOG_ERR("Frame too large to TX: %u\n", uip_len(buf));
return -1;
}
memcpy((void *)context->tx_buf, uip_buf(buf), uip_len(buf));
context->tx_desc.tx_buf1_sz = uip_len(buf);
context->tx_desc.own = 1;
/* Request that the device check for an available TX descriptor, since
* ownership of the descriptor was just transferred to the device.
*/
eth_write(base_addr, REG_ADDR_TX_POLL_DEMAND, 1);
return 1;
}
void eth_dw_isr(struct device *port)
{
struct eth_config *config = port->config->config_info;
uint32_t base_addr = config->base_addr;
uint32_t int_status;
int_status = eth_read(base_addr, REG_ADDR_STATUS);
#ifdef CONFIG_SHARED_IRQ
/* If using with shared IRQ, this function will be called
* by the shared IRQ driver. So check here if the interrupt
* is coming from the GPIO controller (or somewhere else).
*/
if ((int_status & STATUS_RX_INT) == 0) {
return;
}
#endif
eth_rx(port);
/* Acknowledge the interrupt. */
eth_write(base_addr, REG_ADDR_STATUS, STATUS_NORMAL_INT | STATUS_RX_INT);
}
#ifdef CONFIG_PCI
static inline int eth_setup(struct device *dev)
{
struct eth_config *config = dev->config->config_info;
pci_bus_scan_init();
if (!pci_bus_scan(&config->pci_dev))
return 0;
#ifdef CONFIG_PCI_ENUMERATION
config->base_addr = config->pci_dev.addr;
config->irq_num = config->pci_dev.irq;
#endif
pci_enable_regs(&config->pci_dev);
pci_enable_bus_master(&config->pci_dev);
pci_show(&config->pci_dev);
return 1;
}
#else
#define eth_setup(_unused_) (1)
#endif /* CONFIG_PCI */
static int eth_net_tx(struct net_buf *buf);
static int eth_initialize(struct device *port)
{
struct eth_runtime *context = port->driver_data;
struct eth_config *config = port->config->config_info;
uint32_t base_addr;
union {
struct {
uint8_t bytes[6];
uint8_t pad[2];
} __attribute__((packed));
uint32_t words[2];
} mac_addr;
if (!eth_setup(port))
return -EPERM;
base_addr = config->base_addr;
/* Read the MAC address from the device. */
mac_addr.words[1] = eth_read(base_addr, REG_ADDR_MACADDR_HI);
mac_addr.words[0] = eth_read(base_addr, REG_ADDR_MACADDR_LO);
net_set_mac(mac_addr.bytes, sizeof(mac_addr.bytes));
/* Initialize transmit descriptor. */
context->tx_desc.tdes0 = 0;
context->tx_desc.tdes1 = 0;
context->tx_desc.buf1_ptr = (uint8_t *)context->tx_buf;
context->tx_desc.tx_end_of_ring = 1;
context->tx_desc.first_seg_in_frm = 1;
context->tx_desc.last_seg_in_frm = 1;
context->tx_desc.tx_end_of_ring = 1;
/* Initialize receive descriptor. */
context->rx_desc.rdes0 = 0;
context->rx_desc.rdes1 = 0;
context->rx_desc.buf1_ptr = (uint8_t *)context->rx_buf;
context->rx_desc.own = 1;
context->rx_desc.first_desc = 1;
context->rx_desc.last_desc = 1;
context->rx_desc.rx_buf1_sz = UIP_BUFSIZE;
context->rx_desc.rx_end_of_ring = 1;
/* Install transmit and receive descriptors. */
eth_write(base_addr, REG_ADDR_RX_DESC_LIST, (uint32_t)&context->rx_desc);
eth_write(base_addr, REG_ADDR_TX_DESC_LIST, (uint32_t)&context->tx_desc);
eth_write(base_addr, REG_ADDR_MAC_CONF,
/* Set the RMII speed to 100Mbps */
MAC_CONF_14_RMII_100M |
/* Enable full-duplex mode */
MAC_CONF_11_DUPLEX |
/* Enable transmitter */
MAC_CONF_3_TX_EN |
/* Enable receiver */
MAC_CONF_2_RX_EN);
eth_write(base_addr, REG_ADDR_INT_ENABLE,
INT_ENABLE_NORMAL |
/* Enable receive interrupts */
INT_ENABLE_RX);
/* Mask all the MMC interrupts */
eth_write(base_addr, REG_MMC_RX_INTR_MASK, MMC_DEFAULT_MASK);
eth_write(base_addr, REG_MMC_TX_INTR_MASK, MMC_DEFAULT_MASK);
eth_write(base_addr, REG_MMC_RX_IPC_INTR_MASK, MMC_DEFAULT_MASK);
eth_write(base_addr, REG_ADDR_DMA_OPERATION,
/* Enable receive store-and-forward mode for simplicity. */
OP_MODE_25_RX_STORE_N_FORWARD |
/* Enable transmit store-and-forward mode for simplicity. */
OP_MODE_21_TX_STORE_N_FORWARD |
/* Place the transmitter state machine in the Running state. */
OP_MODE_13_START_TX |
/* Place the receiver state machine in the Running state. */
OP_MODE_1_START_RX);
SYS_LOG_INF("Enabled 100M full-duplex mode.");
net_driver_ethernet_register_tx(eth_net_tx);
config->config_func(port);
return 0;
}
/* Bindings to the plaform */
#if CONFIG_ETH_DW_0
static void eth_config_0_irq(struct device *port);
static struct eth_config eth_config_0 = {
.base_addr = ETH_DW_0_BASE_ADDR,
#ifdef CONFIG_ETH_DW_0_IRQ_DIRECT
.irq_num = ETH_DW_0_IRQ,
#endif
#if CONFIG_PCI
.pci_dev.class_type = ETH_DW_PCI_CLASS,
.pci_dev.bus = ETH_DW_0_PCI_BUS,
.pci_dev.dev = ETH_DW_0_PCI_DEV,
.pci_dev.vendor_id = ETH_DW_PCI_VENDOR_ID,
.pci_dev.device_id = ETH_DW_PCI_DEVICE_ID,
.pci_dev.function = ETH_DW_0_PCI_FUNCTION,
.pci_dev.bar = ETH_DW_0_PCI_BAR,
#endif
.config_func = eth_config_0_irq,
#ifdef CONFIG_ETH_DW_0_IRQ_SHARED
.shared_irq_dev_name = CONFIG_ETH_DW_0_IRQ_SHARED_NAME,
#endif
};
static struct eth_runtime eth_0_runtime;
DEVICE_INIT(eth_dw_0, CONFIG_ETH_DW_0_NAME, eth_initialize,
&eth_0_runtime, &eth_config_0,
NANOKERNEL, CONFIG_KERNEL_INIT_PRIORITY_DEVICE);
static int eth_net_tx(struct net_buf *buf)
{
return eth_tx(DEVICE_GET(eth_dw_0), buf);
}
static void eth_config_0_irq(struct device *port)
{
struct eth_config *config = port->config->config_info;
struct device *shared_irq_dev;
#ifdef CONFIG_ETH_DW_0_IRQ_DIRECT
ARG_UNUSED(shared_irq_dev);
IRQ_CONNECT(ETH_DW_0_IRQ, CONFIG_ETH_DW_0_IRQ_PRI, eth_dw_isr,
DEVICE_GET(eth_dw_0), 0);
irq_enable(ETH_DW_0_IRQ);
#elif defined(CONFIG_ETH_DW_0_IRQ_SHARED)
shared_irq_dev = device_get_binding(config->shared_irq_dev_name);
__ASSERT(shared_irq_dev != NULL, "Failed to get eth_dw device binding");
shared_irq_isr_register(shared_irq_dev, (isr_t)eth_dw_isr, port);
shared_irq_enable(shared_irq_dev, port);
#endif
}
#endif /* CONFIG_ETH_DW_0 */