| # |
| # Copyright (c) 2016 Intel Corporation |
| # |
| # Licensed under the Apache License, Version 2.0 (the "License"); |
| # you may not use this file except in compliance with the License. |
| # You may obtain a copy of the License at |
| # |
| # http://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, software |
| # distributed under the License is distributed on an "AS IS" BASIS, |
| # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| # See the License for the specific language governing permissions and |
| # limitations under the License. |
| # |
| |
| menuconfig LPS25HB |
| bool |
| prompt "LPS25HB pressure and temperature" |
| depends on SENSOR && I2C |
| default n |
| help |
| Enable driver for LPS25HB I2C-based pressure and temperature |
| sensor. |
| |
| config LPS25HB_SYS_LOG_LEVEL |
| int "LPS25HB Log level" |
| depends on SYS_LOG && LPS25HB |
| default 0 |
| range 0 4 |
| help |
| Sets log level for LPS25HB driver. |
| |
| Levels are: |
| |
| - 0 OFF: do not write |
| |
| - 1 ERROR: only write SYS_LOG_ERR |
| |
| - 2 WARNING: write SYS_LOG_WRN in addition to previous level |
| |
| - 3 INFO: write SYS_LOG_INF in addition to previous levels |
| |
| - 4 DEBUG: write SYS_LOG_DBG in addition to previous levels |
| |
| config LPS25HB_DEV_NAME |
| string |
| prompt "Device name" |
| default "lps25hb" |
| depends on LPS25HB |
| help |
| Device name with which the LPS25HB sensor is identified. |
| |
| config LPS25HB_INIT_PRIORITY |
| int |
| prompt "Init priority" |
| depends on LPS25HB |
| default 70 |
| help |
| Device driver initialization priority. |
| |
| config LPS25HB_I2C_ADDR |
| hex |
| prompt "I2C address" |
| depends on LPS25HB |
| default "0x5C" |
| help |
| I2C address of the LPS25HB sensor. |
| Use 0x5C if the SA0 pin is pulled to GND or 0x5D if the SA0 |
| pin is pulled to VDD. |
| |
| config LPS25HB_I2C_MASTER_DEV_NAME |
| string |
| prompt "I2C master where LPS25HB is connected" |
| depends on LPS25HB |
| default "I2C_0" |
| help |
| Specify the device name of the I2C master device to which |
| LPS25HB is connected. |
| |
| menu "Attributes" |
| depends on LPS25HB |
| |
| config LPS25HB_SAMPLING_RATE |
| int |
| prompt "Output data rate" |
| depends on LPS25HB |
| default 25 |
| help |
| Sensor output data rate expressed in samples per second. |
| Data rates supported by the chip are 1, 7, 13, 25. |
| |
| endmenu |
