boards/arm/96b_avenger96/96b_avenger96.dts

/*
 * Copyright (c) 2019 Linaro Ltd.
 *
 * SPDX-License-Identifier: Apache-2.0
 */

/dts-v1/;
#include <st/mp1/stm32mp157.dtsi>
#include <st/mp1/stm32mp157aacx-pinctrl.dtsi>

/ {
	model = "Arrow Electronics STM32MP157A Avenger96 board";
	compatible = "arrow,stm32mp157a-avenger96";

	chosen {
		/*
		 * By default, Zephyr console and shell are assigned to
		 * remoteproc. To enable console and shell over UART, uncomment
		 * following lines and set the correct config in
		 * 96b_avenger96_defconfig. Refer "Serial Port" section in
		 * Zephyr board documentation.
		 * zephyr,console = &uart7;
		 * zephyr,shell-uart = &uart7;
		 */
		zephyr,flash = &retram;
		zephyr,sram = &mcusram;
	};

	leds {
		compatible = "gpio-leds";
		green_led_0: led_0 {
			gpios = <&gpiof 3 GPIO_ACTIVE_HIGH>;
			label = "USR0 LED";
		};
		green_led_1: led_1 {
			gpios = <&gpiog 0 GPIO_ACTIVE_HIGH>;
			label = "USR1 LED";
		};
		green_led_2: led_2 {
			gpios = <&gpiog 1 GPIO_ACTIVE_HIGH>;
			label = "USR2 LED";
		};
	};

	aliases {
		led0 = &green_led_0;
		led1 = &green_led_1;
		led2 = &green_led_2;
	};
};

&rcc {
	clock-frequency = <DT_FREQ_M(209)>;
};

&mailbox {
	status = "okay";
};

&uart4 {
	pinctrl-0 = <&uart4_tx_pd1 &uart4_rx_pb2>;
	pinctrl-names = "default";
	current-speed = <115200>;
	status = "okay";
};

&uart7 {
	pinctrl-0 = <&uart7_tx_pe8 &uart7_rx_pe7>;
	pinctrl-names = "default";
	current-speed = <115200>;
	status = "okay";
};