| .. _wsen-hids: |
| |
| WSEN-HIDS: Humidity and Temperature Sensor |
| ########################################## |
| |
| Overview |
| ******** |
| |
| This sample uses the Zephyr :ref:`sensor_api` API driver to periodically |
| read humidity and temperature from the WΓΌrth Elektronik WSEN-HIDS |
| humidity & temperature sensor and displays it on the console. |
| |
| By default, samples are read in polling mode. If desired, the data-ready |
| interrupt of the sensor can be used to trigger reading of samples. |
| |
| Requirements |
| ************ |
| |
| This sample requires a WSEN-HIDS sensor connected via the I2C or SPI interface. |
| |
| References |
| ********** |
| |
| - WSEN-HIDS: https://www.we-online.com/catalog/en/WSEN-HIDS |
| |
| Building and Running |
| ******************** |
| |
| This sample can be configured to support WSEN-HIDS sensors connected via |
| either I2C or SPI. Configuration is done via the :ref:`devicetree <dt-guide>`. |
| The devicetree must have an enabled node with ``compatible = "we,wsen-hids";``. |
| See :dtcompatible:`we,wsen-hids` for the devicetree binding. |
| |
| The sample reads from the sensor and outputs sensor data to the console at |
| regular intervals. If you want to test the sensor's trigger mode, specify |
| the trigger configuration in the prj.conf file and connect the interrupt |
| output from the sensor to your board. |
| |
| .. zephyr-app-commands:: |
| :app: samples/sensor/wsen_hids/ |
| :goals: build flash |
| |
| Sample Output |
| ============= |
| |
| .. code-block:: console |
| |
| [00:00:00.383,209] <inf> MAIN: HIDS device initialized. |
| [00:00:00.384,063] <inf> MAIN: Sample #1 |
| [00:00:00.384,063] <inf> MAIN: Humidity: 29.8 % |
| [00:00:00.384,063] <inf> MAIN: Temperature: 24.9 C |
| [00:00:02.384,979] <inf> MAIN: Sample #2 |
| [00:00:02.385,009] <inf> MAIN: Humidity: 29.7 % |
| [00:00:02.385,009] <inf> MAIN: Temperature: 24.9 C |
| |
| <repeats endlessly every 2 seconds> |
