| &pinctrl { |
| /* Configure pin control bias mode for SPI pins (MASTER) */ |
| p10_0_scb1_spi_m_mosi: p10_0_scb1_spi_m_mosi { |
| pinmux = <DT_CAT1_PINMUX(10, 0, HSIOM_SEL_ACT_8)>; |
| drive-push-pull; |
| }; |
| |
| p10_1_scb1_spi_m_miso: p10_1_scb1_spi_m_miso { |
| pinmux = <DT_CAT1_PINMUX(10, 1, HSIOM_SEL_ACT_8)>; |
| input-enable; |
| }; |
| |
| p10_2_scb1_spi_m_clk: p10_2_scb1_spi_m_clk { |
| pinmux = <DT_CAT1_PINMUX(10, 2, HSIOM_SEL_ACT_8)>; |
| drive-push-pull; |
| }; |
| }; |
| |
| spi: &scb1 { |
| compatible = "infineon,cat1-spi"; |
| status = "okay"; |
| |
| pinctrl-0 = <&p10_0_scb1_spi_m_mosi &p10_1_scb1_spi_m_miso &p10_2_scb1_spi_m_clk>; |
| pinctrl-names = "default"; |
| cs-gpios = <&gpio_prt10 3 GPIO_ACTIVE_LOW>; |
| |
| slow@0 { |
| compatible = "test-spi-loopback-slow"; |
| reg = <0>; |
| spi-max-frequency = <200000>; |
| }; |
| |
| fast@0 { |
| compatible = "test-spi-loopback-fast"; |
| reg = <0>; |
| spi-max-frequency = <1500000>; |
| }; |
| }; |
| |
| &gpio_prt10 { |
| status = "okay"; |
| }; |
