boards/arm/nucleo_f756zg/nucleo_f756zg.dts

/*
 * Copyright (c) 2018 AJ Palmer
 *
 * SPDX-License-Identifier: Apache-2.0
 */

/dts-v1/;
#include <st/f7/stm32f756Xg.dtsi>
#include "arduino_r3_connector.dtsi"

/ {
	model = "STMicroelectronics STM32F756ZG-NUCLEO board";
	compatible = "st,stm32f756zg-nucleo", "st,stm32f756";

	chosen {
		zephyr,console = &usart3;
		zephyr,shell-uart = &usart3;
		zephyr,sram = &sram0;
		zephyr,flash = &flash0;
		zephyr,dtcm = &dtcm;
	};

	leds {
		compatible = "gpio-leds";
		green_led: led_0 {
			gpios = <&gpiob 0 GPIO_INT_ACTIVE_HIGH>;
			label = "User LD1";
		};
		blue_led: led_1 {
			gpios = <&gpiob 7 GPIO_INT_ACTIVE_HIGH>;
			label = "User LD2";
		};
		red_led: led_2 {
			gpios = <&gpiob 14 GPIO_INT_ACTIVE_HIGH>;
			label = "User LD3";
		};
	};

	gpio_keys {
		compatible = "gpio-keys";
		user_button: button_0 {
			label = "User";
			gpios = <&gpioc 13 GPIO_INT_ACTIVE_LOW>;
		};
	};

	aliases {
		led0 = &green_led;
		led1 = &blue_led;
		led2 = &red_led;
		sw0 = &user_button;
	};
};

&usart2 {
	current-speed = <115200>;
	pinctrl-0 = <&usart2_pins_b>;
	pinctrl-names = "default";
	status = "okay";
};

&usart3 {
	current-speed = <115200>;
	pinctrl-0 = <&usart3_pins_b>;
	pinctrl-names = "default";
	status = "okay";
};

&usart6 {
	current-speed = <115200>;
	pinctrl-0 = <&usart6_pins_a>;
	pinctrl-names = "default";
	status = "okay";
};

&usbotg_fs {
	status = "okay";
};

&i2c1 {
	status = "okay";
	clock-frequency = <I2C_BITRATE_FAST>;
};

&timers1 {
	status = "okay";

	pwm {
		status = "okay";
	};
};

&spi1 {
	/*
	 * WARNING: The pin PA7 will conflict on selection of SPI_1 and
	 *          ETH_STM32_HAL. See pinmux.c for further details.
	 */
	status = "okay";
};