blob: 7715bd821fa29107594ae0c26b5575468e67a6c9 [file] [log] [blame]
/*
* Copyright (c) 2016-2019 Nordic Semiconductor ASA
* Copyright (c) 2018 Intel Corporation
*
* SPDX-License-Identifier: Apache-2.0
*/
#include <soc.h>
#include <drivers/clock_control.h>
#include <drivers/clock_control/nrf_clock_control.h>
#include <drivers/timer/system_timer.h>
#include <sys_clock.h>
#include <hal/nrf_timer.h>
#include <spinlock.h>
#define TIMER NRF_TIMER0
#define COUNTER_MAX 0xffffffff
#define CYC_PER_TICK (sys_clock_hw_cycles_per_sec() \
/ CONFIG_SYS_CLOCK_TICKS_PER_SEC)
#define MAX_TICKS ((COUNTER_MAX - CYC_PER_TICK) / CYC_PER_TICK)
static struct k_spinlock lock;
static u32_t last_count;
static u32_t counter_sub(u32_t a, u32_t b)
{
return (a - b) & COUNTER_MAX;
}
static void set_comparator(u32_t cyc)
{
nrf_timer_cc_write(TIMER, 0, cyc & COUNTER_MAX);
}
static u32_t counter(void)
{
nrf_timer_task_trigger(TIMER, nrf_timer_capture_task_get(1));
return nrf_timer_cc_read(TIMER, 1);
}
void timer0_nrf_isr(void *arg)
{
ARG_UNUSED(arg);
TIMER->EVENTS_COMPARE[0] = 0;
k_spinlock_key_t key = k_spin_lock(&lock);
u32_t t = counter();
u32_t dticks = counter_sub(t, last_count) / CYC_PER_TICK;
last_count += dticks * CYC_PER_TICK;
if (!IS_ENABLED(CONFIG_TICKLESS_KERNEL)) {
u32_t next = last_count + CYC_PER_TICK;
/* As below: we're guaranteed to get an interrupt as
* long as it's set two or more cycles in the future
*/
if (counter_sub(next, t) < 3) {
next += CYC_PER_TICK;
}
set_comparator(next);
}
k_spin_unlock(&lock, key);
z_clock_announce(IS_ENABLED(CONFIG_TICKLESS_KERNEL) ? dticks : 1);
}
int z_clock_driver_init(struct device *device)
{
struct device *clock;
ARG_UNUSED(device);
clock = device_get_binding(DT_INST_0_NORDIC_NRF_CLOCK_LABEL "_16M");
if (!clock) {
return -1;
}
/* turn on clock in blocking mode. */
clock_control_on(clock, (void *)1);
nrf_timer_frequency_set(TIMER, NRF_TIMER_FREQ_1MHz);
nrf_timer_bit_width_set(TIMER, NRF_TIMER_BIT_WIDTH_32);
nrf_timer_cc_write(TIMER, 0, CYC_PER_TICK);
nrf_timer_int_enable(TIMER, TIMER_INTENSET_COMPARE0_Msk);
/* Clear the event flag and possible pending interrupt */
nrf_timer_event_clear(TIMER, NRF_TIMER_EVENT_COMPARE0);
NVIC_ClearPendingIRQ(TIMER0_IRQn);
IRQ_CONNECT(TIMER0_IRQn, 1, timer0_nrf_isr, 0, 0);
irq_enable(TIMER0_IRQn);
nrf_timer_task_trigger(TIMER, NRF_TIMER_TASK_CLEAR);
nrf_timer_task_trigger(TIMER, NRF_TIMER_TASK_START);
if (!IS_ENABLED(TICKLESS_KERNEL)) {
set_comparator(counter() + CYC_PER_TICK);
}
return 0;
}
void z_clock_set_timeout(s32_t ticks, bool idle)
{
ARG_UNUSED(idle);
#ifdef CONFIG_TICKLESS_KERNEL
ticks = (ticks == K_FOREVER) ? MAX_TICKS : ticks;
ticks = MAX(MIN(ticks - 1, (s32_t)MAX_TICKS), 0);
k_spinlock_key_t key = k_spin_lock(&lock);
u32_t cyc, dt, t = counter();
bool zli_fixup = IS_ENABLED(CONFIG_ZERO_LATENCY_IRQS);
/* Round up to next tick boundary */
cyc = ticks * CYC_PER_TICK + 1 + counter_sub(t, last_count);
cyc += (CYC_PER_TICK - 1);
cyc = (cyc / CYC_PER_TICK) * CYC_PER_TICK;
cyc += last_count;
if (counter_sub(cyc, t) > 2) {
set_comparator(cyc);
} else {
set_comparator(cyc);
dt = counter_sub(cyc, counter());
if (dt == 0 || dt > 0x7fffff) {
/* Missed it! */
NVIC_SetPendingIRQ(TIMER0_IRQn);
if (IS_ENABLED(CONFIG_ZERO_LATENCY_IRQS)) {
zli_fixup = false;
}
} else if (dt == 1) {
/* Too soon, interrupt won't arrive. */
set_comparator(cyc + 2);
}
/* Otherwise it was two cycles out, we're fine */
}
#ifdef CONFIG_ZERO_LATENCY_IRQS
/* Failsafe. ZLIs can preempt us even though interrupts are
* masked, blowing up the sensitive timing above. If the
* feature is enabled and we haven't recorded the presence of
* a pending interrupt then we need a final check (in a loop!
* because this too can be interrupted) to confirm that the
* comparator is still in the future. Don't bother being
* fancy with cycle counting here, just set an interrupt
* "soon" that we know will get the timer back to a known
* state. This handles (via some hairy modular expressions)
* the wraparound cases where we are preempted for as much as
* half the counter space.
*/
if (zli_fixup && counter_sub(cyc, counter()) <= 0x7fffff) {
while (counter_sub(cyc, counter() + 2) > 0x7fffff) {
cyc = counter() + 3;
set_comparator(cyc);
}
}
#endif
k_spin_unlock(&lock, key);
#endif /* CONFIG_TICKLESS_KERNEL */
}
u32_t z_clock_elapsed(void)
{
if (!IS_ENABLED(CONFIG_TICKLESS_KERNEL)) {
return 0;
}
k_spinlock_key_t key = k_spin_lock(&lock);
u32_t ret = counter_sub(counter(), last_count) / CYC_PER_TICK;
k_spin_unlock(&lock, key);
return ret;
}
u32_t z_timer_cycle_get_32(void)
{
k_spinlock_key_t key = k_spin_lock(&lock);
u32_t ret = counter_sub(counter(), last_count) + last_count;
k_spin_unlock(&lock, key);
return ret;
}