| /* |
| * Copyright (c) 2024 A Labs GmbH |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| * |
| * This overlay defines a fake LoRa PHY node which is required to build the driver. |
| */ |
| |
| #include <zephyr/dt-bindings/lora/sx126x.h> |
| |
| / { |
| chosen { |
| zephyr,code-partition = &slot0_partition; |
| }; |
| |
| aliases { |
| lora0 = &lora; |
| }; |
| |
| test { |
| #address-cells = <1>; |
| #size-cells = <1>; |
| |
| test_spi: spi@33334444 { |
| #address-cells = <1>; |
| #size-cells = <0>; |
| compatible = "vnd,spi"; |
| reg = <0x33334444 0x1000>; |
| status = "okay"; |
| clock-frequency = <2000000>; |
| |
| cs-gpios = <&gpio0 1 GPIO_ACTIVE_LOW>; |
| |
| lora: lora@0 { |
| compatible = "semtech,sx1262"; |
| status = "okay"; |
| reg = <0>; |
| reset-gpios = <&gpio0 2 GPIO_ACTIVE_LOW>; |
| busy-gpios = <&gpio0 3 GPIO_ACTIVE_HIGH>; |
| tx-enable-gpios = <&gpio0 4 GPIO_ACTIVE_LOW>; |
| rx-enable-gpios = <&gpio0 5 GPIO_ACTIVE_LOW>; |
| dio1-gpios = <&gpio0 5 GPIO_ACTIVE_HIGH>; |
| dio2-tx-enable; |
| dio3-tcxo-voltage = <SX126X_DIO3_TCXO_3V3>; |
| tcxo-power-startup-delay-ms = <5>; |
| spi-max-frequency = <1000000>; |
| }; |
| }; |
| }; |
| }; |
