| #!/usr/bin/env bash |
| # Copyright 2023 Nordic Semiconductor |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| source $(dirname "${BASH_SOURCE[0]}")/../../_mesh_test.sh |
| |
| # Note: |
| # Tests must be added in pairs and in sequence. |
| # First test pair: executes Receive Firmware procedure up to certain point using distributor and |
| # target. |
| # Second test pair: tests are executed with `recover` enabled. This means target will recover |
| # settings from persistent storage, which will allow to verify if stored DFU server's phase and |
| # image index were loaded correctly. |
| # Test cases are designed to be run using single target. `dfu_cli_stop` test case in recovery part |
| # plays dummy role, and is there to keep order of settings files being loaded. |
| conf=prj_mesh1d1_conf |
| overlay=overlay_pst_conf |
| RunTest dfu_dist_recover_phase dfu_cli_stop dfu_target_dfu_stop -- -argstest \ |
| recover=0 expected-phase=2 |
| |
| conf=prj_mesh1d1_conf |
| overlay=overlay_pst_conf |
| RunTest dfu_dist_recover_phase dfu_cli_stop dfu_target_dfu_stop -- -argstest \ |
| recover=1 expected-phase=3 |
| |
| conf=prj_mesh1d1_conf |
| overlay=overlay_pst_conf |
| RunTest dfu_dist_recover_phase dfu_cli_stop dfu_target_dfu_stop -- -argstest \ |
| recover=1 expected-phase=4 |
| |
| conf=prj_mesh1d1_conf |
| overlay=overlay_pst_conf |
| RunTest dfu_dist_recover_phase dfu_cli_stop dfu_target_dfu_stop -- -argstest \ |
| recover=1 expected-phase=6 |
| |
| # Use phase `BT_MESH_DFU_PHASE_APPLY_SUCCESS` as marker to bring whole procedure to an end |
| conf=prj_mesh1d1_conf |
| overlay=overlay_pst_conf |
| RunTest dfu_dist_recover_phase dfu_cli_stop dfu_target_dfu_stop -- -argstest \ |
| recover=1 expected-phase=8 |
| |
| # To test recovery from Verify Fail begin new distribution that will end there, |
| # reboot devices and continue to Applying. |
| conf=prj_mesh1d1_conf |
| overlay=overlay_pst_conf |
| RunTest dfu_dist_recover_phase dfu_cli_stop dfu_target_dfu_stop -- -argstest \ |
| recover=0 expected-phase=5 |
| |
| conf=prj_mesh1d1_conf |
| overlay=overlay_pst_conf |
| RunTest dfu_dist_recover_phase dfu_cli_stop dfu_target_dfu_stop -- -argstest \ |
| recover=1 expected-phase=6 |
