| /* |
| * Copyright (c) 2016 BayLibre, SAS |
| * Copyright (c) 2017 Linaro Ltd |
| * Copyright (c) 2024 Intel Corporation |
| * Copyright (c) 2025 STMicroelectronics |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| #include <zephyr/drivers/clock_control/stm32_clock_control.h> |
| #include <zephyr/drivers/clock_control.h> |
| #include <zephyr/drivers/pinctrl.h> |
| |
| #define LOG_LEVEL CONFIG_I2C_LOG_LEVEL |
| #include <zephyr/logging/log.h> |
| LOG_MODULE_REGISTER(i2c_ll_stm32_common); |
| |
| #include "i2c_ll_stm32.h" |
| |
| #ifdef CONFIG_I2C_STM32_COMBINED_INTERRUPT |
| void i2c_stm32_combined_isr(void *arg) |
| { |
| const struct device *dev = (const struct device *) arg; |
| |
| if (i2c_stm32_error(dev)) { |
| return; |
| } |
| i2c_stm32_event(dev); |
| } |
| #else |
| void i2c_stm32_event_isr(void *arg) |
| { |
| const struct device *dev = (const struct device *) arg; |
| |
| i2c_stm32_event(dev); |
| } |
| |
| void i2c_stm32_error_isr(void *arg) |
| { |
| const struct device *dev = (const struct device *) arg; |
| |
| (void)i2c_stm32_error(dev); |
| } |
| #endif |
| |
| int i2c_stm32_activate(const struct device *dev) |
| { |
| int ret; |
| const struct i2c_stm32_config *cfg = dev->config; |
| const struct device *const clk = DEVICE_DT_GET(STM32_CLOCK_CONTROL_NODE); |
| |
| /* Move pins to active/default state */ |
| ret = pinctrl_apply_state(cfg->pcfg, PINCTRL_STATE_DEFAULT); |
| if (ret < 0) { |
| LOG_ERR("I2C pinctrl setup failed (%d)", ret); |
| return ret; |
| } |
| |
| /* Enable device clock. */ |
| if (clock_control_on(clk, |
| (clock_control_subsys_t) &cfg->pclken[0]) != 0) { |
| LOG_ERR("i2c: failure enabling clock"); |
| return -EIO; |
| } |
| |
| return 0; |
| } |
| |
| #ifdef CONFIG_PM_DEVICE |
| int i2c_stm32_suspend(const struct device *dev) |
| { |
| int ret; |
| const struct i2c_stm32_config *cfg = dev->config; |
| const struct device *const clk = DEVICE_DT_GET(STM32_CLOCK_CONTROL_NODE); |
| |
| /* Disable device clock. */ |
| ret = clock_control_off(clk, (clock_control_subsys_t)&cfg->pclken[0]); |
| if (ret < 0) { |
| LOG_ERR("failure disabling I2C clock"); |
| return ret; |
| } |
| |
| /* Move pins to sleep state */ |
| ret = pinctrl_apply_state(cfg->pcfg, PINCTRL_STATE_SLEEP); |
| if (ret == -ENOENT) { |
| /* Warn but don't block suspend */ |
| LOG_WRN("I2C pinctrl sleep state not available "); |
| } else if (ret < 0) { |
| return ret; |
| } |
| |
| return 0; |
| } |
| |
| int i2c_stm32_pm_action(const struct device *dev, enum pm_device_action action) |
| { |
| int err; |
| |
| switch (action) { |
| case PM_DEVICE_ACTION_RESUME: |
| err = i2c_stm32_activate(dev); |
| break; |
| case PM_DEVICE_ACTION_SUSPEND: |
| err = i2c_stm32_suspend(dev); |
| break; |
| default: |
| return -ENOTSUP; |
| } |
| |
| return err; |
| } |
| #endif |