| menuconfig UART_ATMEL_SAM3 |
| bool "[deprecated] Atmel SAM3 family processor UART driver" |
| default n |
| select SERIAL_HAS_DRIVER |
| depends on SOC_SERIES_SAM3X |
| help |
| |
| This driver is deprecated and will be removed. Use |
| "Atmel SAM MCU family UART driver" instead. |
| |
| This option enables the UART driver for Atmel SAM3 |
| family processors. Note that there is only one |
| UART controller on SAM3. It has only two wires |
| for RX and TX, and does not have other pins |
| (such as CTS and RTS). |
| |
| config UART_ATMEL_SAM3_IRQ_PRI |
| int "Atmel SAM3 UART Interrupt Priority" |
| default 0 |
| depends on UART_ATMEL_SAM3 |
| help |
| The interrupt priority for UART port. |
| |
| config UART_ATMEL_SAM3_BAUD_RATE |
| int "Atmel SAM3 UART Baud Rate" |
| default 0 |
| depends on UART_ATMEL_SAM3 |
| help |
| The baud rate for UART port to be set to at boot. |
| |
| config UART_ATMEL_SAM3_CLK_FREQ |
| int "Atmel SAM3 UART Clock Frequency" |
| default 0 |
| depends on UART_ATMEL_SAM3 |
| help |
| The clock frequency for UART port. |