blob: 3d213032c07756d812afb3b2c81fbc6968d98933 [file] [log] [blame]
# Kconfig - USB device configuration options
#
# Copyright (c) 2016 Wind River Systems, Inc.
#
# SPDX-License-Identifier: Apache-2.0
#
if USB
config USB_DEVICE_DRIVER
bool
config USB_DW
bool "Designware USB Device Controller Driver"
select USB_DEVICE_DRIVER
help
Designware USB Device Controller Driver.
config USB_DW_IRQ_PRI
int "DesignWare USB Driver Interrupt priority"
depends on USB_DW
help
USB interrupt priority.
config USB_DW_USB_2_0
bool "DesignWare Controller and PHY support for USB specification 2.0"
depends on USB_DW
help
Indicates whether or not USB specification version 2.0 is supported
config USB_DC_STM32
bool "USB device controller driver for STM32 devices"
depends on SOC_FAMILY_STM32
select USB_DEVICE_DRIVER
select USE_STM32_LL_USB if !SOC_SERIES_STM32F0X && !SOC_SERIES_STM32F3X && !SOC_SERIES_STM32L0X
select USE_STM32_HAL_PCD
select USE_STM32_HAL_PCD_EX
select HAS_DTS_USB
help
Enable USB support on the STM32 F0, F1, F2, F3, F4, F7, L0 and L4 family of
processors.
config USB_DC_SAM0
bool "SAM0 series USB Device Controller driver"
default y
depends on SOC_FAMILY_SAM0
select USB_DEVICE_DRIVER
help
SAM0 family USB device controller Driver.
config USB_DC_SAM
bool "SAM series USB HS Device Controller driver"
depends on SOC_SERIES_SAME70
select USB_DEVICE_DRIVER
select HAS_DTS_USB
help
SAM family USB HS device controller Driver.
menuconfig USB_NRF52840
bool "Nordic Semiconductor nRF52840 USB Device Controller Driver"
default y
depends on SOC_NRF52840
select USB_DEVICE_DRIVER
select HAS_DTS_USB
select NRFX_USBD
select USB_DEVICE_REMOTE_WAKEUP
help
nRF52840 USB Device Controller Driver
config USB_NRFX_EVT_QUEUE_SIZE
int "USBD event queue size"
default 32
depends on USB_NRF52840
help
Size of the driver's internal event queue.
Required size will depend on number of endpoints (class instances) in use.
config USB_KINETIS
bool "Kinetis USB Device Controller Driver"
select USB_DEVICE_DRIVER
help
Kinetis USB Device Controller Driver.
module = USB_DRIVER
module-str = usb driver
source "subsys/logging/Kconfig.template.log_config"
config USB_DC_STM32_DISCONN_ENABLE
bool
depends on USB_DC_STM32
help
Say Y if your board uses USB DISCONNECT pin to enable the
pull-up resistor on USB DP.
config USB_NATIVE_POSIX
bool "Native Posix USB Device Controller Driver"
select USB_DEVICE_DRIVER
help
Native Posix USB Device Controller Driver.
endif # USB