| CONFIG_GPIO=y |
| CONFIG_SERIAL=y |
| CONFIG_MAIN_STACK_SIZE=512 |
| CONFIG_SYSTEM_WORKQUEUE_STACK_SIZE=512 |
| CONFIG_BT=y |
| CONFIG_BT_WAIT_NOP=y |
| CONFIG_BT_HCI_RAW=y |
| CONFIG_BT_MAX_CONN=16 |
| CONFIG_BT_TINYCRYPT_ECC=n |
| CONFIG_BT_CTLR_DTM_HCI=y |
| CONFIG_BT_CTLR_ASSERT_HANDLER=y |
| |
| # Connect the MCU interface pins to the nRF9160 |
| # We will instantiate UART1 on these pins |
| CONFIG_BOARD_PCA10090_INTERFACE0_MCU=y |
| CONFIG_BOARD_PCA10090_INTERFACE1_MCU=y |
| |
| # Enable reset pin on P1.02 |
| CONFIG_BOARD_PCA10090_NRF52840_RESET=y |
| CONFIG_BOARD_PCA10090_NRF52840_RESET_P1_02=y |
| |
| # Use UART1 for HCI |
| CONFIG_UART_1_NRF_UARTE=y |
| CONFIG_UART_1_NRF_FLOW_CONTROL=y |
| CONFIG_UART_INTERRUPT_DRIVEN=y |
| CONFIG_BT_CTLR_TO_HOST_UART_DEV_NAME="UART_1" |
