| /* |
| * Copyright (c) 2019 Western Digital Corporation or its affiliates |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| #define DT_DRV_COMPAT opencores_spi_simple |
| |
| #define LOG_LEVEL CONFIG_SPI_LOG_LEVEL |
| #include <logging/log.h> |
| LOG_MODULE_REGISTER(spi_oc_simple); |
| |
| #include <sys/sys_io.h> |
| #include <drivers/spi.h> |
| |
| #include "spi_context.h" |
| #include "spi_oc_simple.h" |
| |
| /* Bit 5:4 == ESPR, Bit 1:0 == SPR */ |
| uint8_t DIVIDERS[] = { 0x00, /* 2 */ |
| 0x01, /* 4 */ |
| 0x10, /* 8 */ |
| 0x02, /* 16 */ |
| 0x03, /* 32 */ |
| 0x11, /* 64 */ |
| 0x12, /* 128 */ |
| 0x13, /* 256 */ |
| 0x20, /* 512 */ |
| 0x21, /* 1024 */ |
| 0x22, /* 2048 */ |
| 0x23 }; /* 4096 */ |
| |
| static int spi_oc_simple_configure(const struct spi_oc_simple_cfg *info, |
| struct spi_oc_simple_data *spi, |
| const struct spi_config *config) |
| { |
| uint8_t spcr = 0U; |
| int i; |
| |
| if (spi_context_configured(&spi->ctx, config)) { |
| /* Nothing to do */ |
| return 0; |
| } |
| |
| if (config->operation & SPI_HALF_DUPLEX) { |
| LOG_ERR("Half-duplex not supported"); |
| return -ENOTSUP; |
| } |
| |
| /* Simple SPI only supports master mode */ |
| if (spi_context_is_slave(&spi->ctx)) { |
| LOG_ERR("Slave mode not supported"); |
| return -ENOTSUP; |
| } |
| |
| if ((config->operation & (SPI_MODE_LOOP | SPI_TRANSFER_LSB)) || |
| (IS_ENABLED(CONFIG_SPI_EXTENDED_MODES) && |
| (config->operation & |
| (SPI_LINES_DUAL | SPI_LINES_QUAD | SPI_LINES_OCTAL)))) { |
| LOG_ERR("Unsupported configuration"); |
| return -EINVAL; |
| } |
| |
| /* SPI mode */ |
| if (SPI_MODE_GET(config->operation) & SPI_MODE_CPOL) { |
| spcr |= SPI_OC_SIMPLE_SPCR_CPOL; |
| } |
| |
| if (SPI_MODE_GET(config->operation) & SPI_MODE_CPHA) { |
| spcr |= SPI_OC_SIMPLE_SPCR_CPHA; |
| } |
| |
| /* Set clock divider */ |
| for (i = 0; i < 12; i++) |
| if ((config->frequency << (i + 1)) > |
| CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC) { |
| break; |
| } |
| |
| sys_write8((DIVIDERS[i] >> 4) & 0x3, SPI_OC_SIMPLE_SPER(info)); |
| spcr |= (DIVIDERS[i] & 0x3); |
| |
| /* Configure and Enable SPI controller */ |
| sys_write8(spcr | SPI_OC_SIMPLE_SPCR_SPE, SPI_OC_SIMPLE_SPCR(info)); |
| |
| spi->ctx.config = config; |
| |
| return 0; |
| } |
| |
| int spi_oc_simple_transceive(const struct device *dev, |
| const struct spi_config *config, |
| const struct spi_buf_set *tx_bufs, |
| const struct spi_buf_set *rx_bufs) |
| { |
| const struct spi_oc_simple_cfg *info = dev->config; |
| struct spi_oc_simple_data *spi = SPI_OC_SIMPLE_DATA(dev); |
| struct spi_context *ctx = &spi->ctx; |
| |
| uint8_t rx_byte; |
| size_t i; |
| size_t cur_xfer_len; |
| int rc; |
| |
| /* Lock the SPI Context */ |
| spi_context_lock(ctx, false, NULL, config); |
| |
| spi_oc_simple_configure(info, spi, config); |
| |
| /* Set chip select */ |
| if (config->cs) { |
| spi_context_cs_control(&spi->ctx, true); |
| } else { |
| sys_write8(1 << config->slave, SPI_OC_SIMPLE_SPSS(info)); |
| } |
| |
| spi_context_buffers_setup(ctx, tx_bufs, rx_bufs, 1); |
| |
| while (spi_context_tx_buf_on(ctx) || spi_context_rx_buf_on(ctx)) { |
| cur_xfer_len = spi_context_longest_current_buf(ctx); |
| |
| for (i = 0; i < cur_xfer_len; i++) { |
| |
| /* Write byte */ |
| if (spi_context_tx_buf_on(ctx)) { |
| sys_write8(*ctx->tx_buf, |
| SPI_OC_SIMPLE_SPDR(info)); |
| spi_context_update_tx(ctx, 1, 1); |
| } else { |
| sys_write8(0, SPI_OC_SIMPLE_SPDR(info)); |
| } |
| |
| /* Wait for rx FIFO empty flag to clear */ |
| while (sys_read8(SPI_OC_SIMPLE_SPSR(info)) & 0x1) { |
| } |
| |
| /* Get received byte */ |
| rx_byte = sys_read8(SPI_OC_SIMPLE_SPDR(info)); |
| |
| /* Store received byte if rx buffer is on */ |
| if (spi_context_rx_on(ctx)) { |
| *ctx->rx_buf = rx_byte; |
| spi_context_update_rx(ctx, 1, 1); |
| } |
| } |
| } |
| |
| /* Clear chip-select */ |
| if (config->cs) { |
| spi_context_cs_control(&spi->ctx, false); |
| } else { |
| sys_write8(0 << config->slave, SPI_OC_SIMPLE_SPSS(info)); |
| } |
| |
| spi_context_complete(ctx, 0); |
| rc = spi_context_wait_for_completion(ctx); |
| |
| spi_context_release(ctx, rc); |
| |
| return rc; |
| } |
| |
| #ifdef CONFIG_SPI_ASYNC |
| static int spi_oc_simple_transceive_async(const struct device *dev, |
| const struct spi_config *config, |
| const struct spi_buf_set *tx_bufs, |
| const struct spi_buf_set *rx_bufs, |
| struct k_poll_signal *async) |
| { |
| return -ENOTSUP; |
| } |
| #endif /* CONFIG_SPI_ASYNC */ |
| |
| int spi_oc_simple_release(const struct device *dev, |
| const struct spi_config *config) |
| { |
| spi_context_unlock_unconditionally(&SPI_OC_SIMPLE_DATA(dev)->ctx); |
| return 0; |
| } |
| |
| static struct spi_driver_api spi_oc_simple_api = { |
| .transceive = spi_oc_simple_transceive, |
| .release = spi_oc_simple_release, |
| #ifdef CONFIG_SPI_ASYNC |
| .transceive_async = spi_oc_simple_transceive_async, |
| #endif /* CONFIG_SPI_ASYNC */ |
| }; |
| |
| int spi_oc_simple_init(const struct device *dev) |
| { |
| int err; |
| const struct spi_oc_simple_cfg *info = dev->config; |
| struct spi_oc_simple_data *data = dev->data; |
| |
| /* Clear chip selects */ |
| sys_write8(0, SPI_OC_SIMPLE_SPSS(info)); |
| |
| err = spi_context_cs_configure_all(&data->ctx); |
| if (err < 0) { |
| return err; |
| } |
| |
| /* Make sure the context is unlocked */ |
| spi_context_unlock_unconditionally(&SPI_OC_SIMPLE_DATA(dev)->ctx); |
| |
| /* Initial clock stucks high, so add this workaround */ |
| sys_write8(SPI_OC_SIMPLE_SPCR_SPE, SPI_OC_SIMPLE_SPCR(info)); |
| sys_write8(0, SPI_OC_SIMPLE_SPDR(info)); |
| while (sys_read8(SPI_OC_SIMPLE_SPSR(info)) & 0x1) { |
| } |
| |
| sys_read8(SPI_OC_SIMPLE_SPDR(info)); |
| |
| return 0; |
| } |
| |
| #define SPI_OC_INIT(inst) \ |
| static struct spi_oc_simple_cfg spi_oc_simple_cfg_##inst = { \ |
| .base = DT_INST_REG_ADDR_BY_NAME(inst, control), \ |
| }; \ |
| \ |
| static struct spi_oc_simple_data spi_oc_simple_data_##inst = { \ |
| SPI_CONTEXT_INIT_LOCK(spi_oc_simple_data_##inst, ctx), \ |
| SPI_CONTEXT_INIT_SYNC(spi_oc_simple_data_##inst, ctx), \ |
| SPI_CONTEXT_CS_GPIOS_INITIALIZE(DT_DRV_INST(inst), ctx) \ |
| }; \ |
| \ |
| DEVICE_DT_INST_DEFINE(inst, \ |
| spi_oc_simple_init, \ |
| NULL, \ |
| &spi_oc_simple_data_##inst, \ |
| &spi_oc_simple_cfg_##inst, \ |
| POST_KERNEL, \ |
| CONFIG_SPI_INIT_PRIORITY, \ |
| &spi_oc_simple_api); |
| |
| DT_INST_FOREACH_STATUS_OKAY(SPI_OC_INIT) |