| # Copyright (c) 2025 ITE Corporation. All Rights Reserved. |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| config I2C_ITE_IT51XXX |
| bool "ITE IT51XXX I2C driver" |
| default y |
| depends on DT_HAS_ITE_IT51XXX_I2C_ENABLED |
| select PINCTRL |
| select I2C_BITBANG |
| help |
| Enable I2C support on IT51XXX series. |
| Supports nine hosts and three targets and each one able to located |
| at I2C interface0~8. |
| Three I2C targets on design A, B and C. Support 16 bytes dedicated |
| FIFO mode for read/write. |
| Supported Speeds: 50kHz, 100kHz, 400kHz and 1MHz. |
| This driver supports repeated start. |
| |
| if I2C_ITE_IT51XXX |
| |
| config I2C_IT51XXX_FIFO_MODE |
| bool "IT51XXX I2C FIFO mode" |
| default y |
| help |
| This is an option to enable FIFO mode which can reduce the time |
| between each byte to improve the I2C bus clock stretching during |
| I2C transaction. |
| The I2C controller supports two 32-bytes FIFOs, |
| FIFO1 supports I2C 0, and FIFO2 supports other ports. |
| I2C FIFO mode of IT51XXX can support I2C APIs including: |
| i2c_write(), i2c_read(), i2c_burst_read. |
| |
| endif # I2C_ITE_IT51XXX |
| |
| if I2C_TARGET |
| |
| config I2C_TARGET_IT51XXX_MAX_BUF_SIZE |
| int "It is allowed to configure the dedicated FIFO size up to 256 bytes." |
| default 256 |
| |
| config I2C_IT51XXX_MAX_SHARE_FIFO_SIZE |
| int "It is allowed to configure the shared FIFO size up to 256 bytes." |
| range 16 256 |
| default 256 |
| |
| config SOC_IT51XXX_CPU_IDLE_GATING |
| default y |
| help |
| This option is used when the I2C target shared FIFO property is enabled. |
| |
| endif # I2C_TARGET |
