| Title: Test to verify the SW Vector Relay feature (ARM Only) |
| |
| Description: |
| |
| This test verifies that the vector table relay feature |
| (CONFIG_SW_VECTOR_RELAY=y) works as expected. Only for |
| ARM Cortex-M targets. |
| |
| --------------------------------------------------------------------------- |
| |
| Building and Running Project: |
| |
| This project outputs to the console. It can be built and executed on QEMU as |
| follows: |
| |
| ninja/make run |
| |
| --------------------------------------------------------------------------- |
| |
| Troubleshooting: |
| |
| Problems caused by out-dated project information can be addressed by |
| issuing one of the following commands then rebuilding the project: |
| |
| ninja/make clean # discard results of previous builds |
| # but keep existing configuration info |
| or |
| ninja/make pristine # discard results of previous builds |
| # and restore pre-defined configuration info |
| |
| --------------------------------------------------------------------------- |
| |
| Sample Output: |
| |
| ***** Booting Zephyr OS build zephyr-v1.14.0-1726-gb95a71960622 ***** |
| Running test suite arm_sw_vector_relay |
| =================================================================== |
| starting test - test_arm_sw_vector_relay |
| PASS - test_arm_sw_vector_relay |
| =================================================================== |
| Test suite arm_sw_vector_relay succeeded |
| =================================================================== |
| PROJECT EXECUTION SUCCESSFUL |
