| # nRF9160 innblue V2.2 board configuration |
| |
| # Copyright (c) 2020 InnBlue |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| if BOARD_INNBLUE22 |
| |
| # For the secure version of the board the firmware is linked at the beginning |
| # of the flash, or into the code-partition defined in DT if it is intended to |
| # be loaded by MCUboot. If the secure firmware is to be combined with a non- |
| # secure image (TRUSTED_EXECUTION_SECURE=y), the secure FW image shall always |
| # be restricted to the size of its code partition. |
| # For the non-secure version of the board, the firmware |
| # must be linked into the code-partition (non-secure) defined in DT, regardless. |
| # Apply this configuration below by setting the Kconfig symbols used by |
| # the linker according to the information extracted from DT partitions. |
| |
| |
| # Workaround for not being able to have commas in macro arguments |
| DT_CHOSEN_Z_CODE_PARTITION := zephyr,code-partition |
| |
| if BOARD_INNBLUE22_NRF9160 && TRUSTED_EXECUTION_SECURE |
| |
| config FLASH_LOAD_SIZE |
| default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION)) |
| |
| endif # BOARD_INNBLUE22_NRF9160 && TRUSTED_EXECUTION_SECURE |
| |
| if BOARD_INNBLUE22_NRF9160_NS |
| |
| config FLASH_LOAD_OFFSET |
| default $(dt_chosen_reg_addr_hex,$(DT_CHOSEN_Z_CODE_PARTITION)) |
| |
| config FLASH_LOAD_SIZE |
| default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION)) |
| |
| endif # BOARD_INNBLUE22_NRF9160_NS |
| |
| config BT_HCI_VS |
| default y if BT |
| |
| config REGULATOR |
| default y if SENSOR |
| |
| endif # BOARD_INNBLUE22 |
