| # Copyright (c) 2025 Microchip Technology Inc. |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| menuconfig MTCH9010 |
| bool "MTCH9010" |
| default y |
| depends on DT_HAS_MICROCHIP_MTCH9010_ENABLED |
| help |
| Configure the MTCH9010 driver |
| |
| if MTCH9010 |
| |
| config MTCH9010_RESET_ON_STARTUP |
| bool "Reset MTCH9010 on Startup" |
| default y |
| help |
| Resets the MTCH9010 before the driver configures it. |
| If disabled and the MTCH9010 was configured already, configuration will fail. |
| |
| config MTCH9010_LOCK_ON_STARTUP |
| bool "Save MTCH9010 Settings on Startup" |
| default n |
| help |
| If set, this option will assert SYS_LK after initialization. |
| The sensor will use these parameters if SYS_LK is asserted on the next POR. |
| |
| config MTCH9010_SAMPLE_DELAY_TIMEOUT_MS |
| int "Maximum wait time to get a sample (ms)" |
| default 500 |
| help |
| Sets the maximum amount of time in milliseconds to wait for a response from the MTCH9010 |
| when asking for a sample. Conductive mode is much faster than capacitive mode. |
| |
| config MTCH9010_OVERRIDE_DELAY_ENABLE |
| bool "Override Delay if not Wake on Request" |
| default y |
| help |
| If the MTCH9010 has a sleep period defined, the wake pin will not wake the device. |
| If this option is set, the API will allow for <sleep period + timeout> length |
| delays during fetch. Otherwise, the API will use the normal timeout, and likely fail. |
| |
| config MTCH9010_REFERENCE_AVERAGING_COUNT |
| int "Reference Averaging Count" |
| default 1 |
| range 1 64 |
| help |
| If the MTCH9010 is using the current measurement as its reference, then this |
| is the number of samples to average. |
| |
| config MTCH9010_HEARTBEAT_MONITORING_ENABLE |
| bool "Heartbeat Monitoring" |
| default y |
| help |
| Configures monitoring of the heartbeat output |
| |
| # Logging Settings |
| module = MTCH9010 |
| module-str = MTCH9010 |
| source "subsys/logging/Kconfig.template.log_config" |
| |
| endif |
