| /* |
| * Copyright (c) 2018 STMicroelectronics |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| #define DT_DRV_COMPAT st_mpxxdtyy |
| |
| #include "mpxxdtyy.h" |
| #include <zephyr/drivers/i2s.h> |
| |
| #define LOG_LEVEL CONFIG_AUDIO_DMIC_LOG_LEVEL |
| #include <zephyr/logging/log.h> |
| LOG_MODULE_DECLARE(mpxxdtyy); |
| |
| #if DT_ANY_INST_ON_BUS_STATUS_OKAY(i2s) |
| |
| #define NUM_RX_BLOCKS 4 |
| #define PDM_BLOCK_MAX_SIZE_BYTES 512 |
| |
| K_MEM_SLAB_DEFINE(rx_pdm_i2s_mslab, PDM_BLOCK_MAX_SIZE_BYTES, NUM_RX_BLOCKS, 1); |
| |
| int mpxxdtyy_i2s_read(const struct device *dev, uint8_t stream, void **buffer, |
| size_t *size, int32_t timeout) |
| { |
| int ret; |
| const struct mpxxdtyy_config *config = dev->config; |
| struct mpxxdtyy_data *const data = dev->data; |
| void *pdm_block, *pcm_block; |
| size_t pdm_size; |
| TPDMFilter_InitStruct *pdm_filter = &data->pdm_filter[0]; |
| |
| ret = i2s_read(config->comm_master, &pdm_block, &pdm_size); |
| if (ret != 0) { |
| LOG_ERR("read failed (%d)", ret); |
| return ret; |
| } |
| |
| ret = k_mem_slab_alloc(data->pcm_mem_slab, |
| &pcm_block, K_NO_WAIT); |
| if (ret < 0) { |
| return ret; |
| } |
| |
| sw_filter_lib_run(pdm_filter, pdm_block, pcm_block, pdm_size, |
| data->pcm_mem_size); |
| k_mem_slab_free(&rx_pdm_i2s_mslab, &pdm_block); |
| |
| *buffer = pcm_block; |
| *size = data->pcm_mem_size; |
| |
| return 0; |
| } |
| |
| int mpxxdtyy_i2s_trigger(const struct device *dev, enum dmic_trigger cmd) |
| { |
| int ret; |
| const struct mpxxdtyy_config *config = dev->config; |
| struct mpxxdtyy_data *const data = dev->data; |
| enum i2s_trigger_cmd i2s_cmd; |
| enum dmic_state tmp_state; |
| |
| switch (cmd) { |
| case DMIC_TRIGGER_START: |
| if (data->state == DMIC_STATE_CONFIGURED) { |
| tmp_state = DMIC_STATE_ACTIVE; |
| i2s_cmd = I2S_TRIGGER_START; |
| } else { |
| return 0; |
| } |
| break; |
| case DMIC_TRIGGER_STOP: |
| if (data->state == DMIC_STATE_ACTIVE) { |
| tmp_state = DMIC_STATE_CONFIGURED; |
| i2s_cmd = I2S_TRIGGER_STOP; |
| } else { |
| return 0; |
| } |
| break; |
| default: |
| return -EINVAL; |
| } |
| |
| ret = i2s_trigger(config->comm_master, I2S_DIR_RX, i2s_cmd); |
| if (ret != 0) { |
| LOG_ERR("trigger failed with %d error", ret); |
| return ret; |
| } |
| |
| data->state = tmp_state; |
| return 0; |
| } |
| |
| int mpxxdtyy_i2s_configure(const struct device *dev, struct dmic_cfg *cfg) |
| { |
| int ret; |
| const struct mpxxdtyy_config *config = dev->config; |
| struct mpxxdtyy_data *const data = dev->data; |
| uint8_t chan_size = cfg->streams->pcm_width; |
| uint32_t audio_freq = cfg->streams->pcm_rate; |
| uint16_t factor; |
| |
| /* PCM buffer size */ |
| data->pcm_mem_slab = cfg->streams->mem_slab; |
| data->pcm_mem_size = cfg->streams->block_size; |
| |
| /* check requested min pdm frequency */ |
| if (cfg->io.min_pdm_clk_freq < MPXXDTYY_MIN_PDM_FREQ || |
| cfg->io.min_pdm_clk_freq > cfg->io.max_pdm_clk_freq) { |
| return -EINVAL; |
| } |
| |
| /* check requested max pdm frequency */ |
| if (cfg->io.max_pdm_clk_freq > MPXXDTYY_MAX_PDM_FREQ || |
| cfg->io.max_pdm_clk_freq < cfg->io.min_pdm_clk_freq) { |
| return -EINVAL; |
| } |
| |
| factor = sw_filter_lib_init(dev, cfg); |
| if (factor == 0U) { |
| return -EINVAL; |
| } |
| |
| /* configure I2S channels */ |
| struct i2s_config i2s_cfg; |
| |
| i2s_cfg.word_size = chan_size; |
| i2s_cfg.channels = cfg->channel.req_num_chan; |
| i2s_cfg.format = I2S_FMT_DATA_FORMAT_LEFT_JUSTIFIED | |
| I2S_FMT_BIT_CLK_INV; |
| i2s_cfg.options = I2S_OPT_FRAME_CLK_MASTER | I2S_OPT_BIT_CLK_MASTER; |
| i2s_cfg.frame_clk_freq = audio_freq * factor / chan_size; |
| i2s_cfg.block_size = data->pcm_mem_size * (factor / chan_size); |
| i2s_cfg.mem_slab = &rx_pdm_i2s_mslab; |
| i2s_cfg.timeout = 2000; |
| |
| ret = i2s_configure(config->comm_master, I2S_DIR_RX, &i2s_cfg); |
| if (ret != 0) { |
| LOG_ERR("I2S device configuration error"); |
| return ret; |
| } |
| |
| data->state = DMIC_STATE_CONFIGURED; |
| return 0; |
| } |
| #endif /* DT_ANY_INST_ON_BUS_STATUS_OKAY(i2s) */ |