| # ST Microelectronics LPS22HH pressure and temperature sensor |
| |
| # Copyright (c) 2019 STMicroelectronics |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| menuconfig LPS22HH |
| bool "LPS22HH pressure and temperature" |
| default y |
| depends on DT_HAS_ST_LPS22HH_ENABLED |
| depends on ZEPHYR_HAL_ST_MODULE |
| select I2C if $(dt_compat_on_bus,$(DT_COMPAT_ST_LPS22HH),i2c) |
| select I3C if $(dt_compat_on_bus,$(DT_COMPAT_ST_LPS22HH),i3c) |
| select SPI if $(dt_compat_on_bus,$(DT_COMPAT_ST_LPS22HH),spi) |
| select HAS_STMEMSC |
| select USE_STDC_LPS22HH |
| help |
| Enable driver for LPS22HH I2C-based pressure and temperature |
| sensor. |
| |
| if LPS22HH |
| |
| choice LPS22HH_TRIGGER_MODE |
| prompt "Trigger mode" |
| default LPS22HH_TRIGGER_GLOBAL_THREAD |
| help |
| Specify the type of triggering to be used by the driver. |
| |
| config LPS22HH_TRIGGER_NONE |
| bool "No trigger" |
| |
| config LPS22HH_TRIGGER_GLOBAL_THREAD |
| bool "Use global thread" |
| depends on GPIO |
| depends on $(dt_compat_any_has_prop,$(DT_COMPAT_ST_LPS22HH),drdy-gpios) |
| select LPS22HH_TRIGGER |
| |
| config LPS22HH_TRIGGER_OWN_THREAD |
| bool "Use own thread" |
| depends on GPIO |
| depends on $(dt_compat_any_has_prop,$(DT_COMPAT_ST_LPS22HH),drdy-gpios) |
| select LPS22HH_TRIGGER |
| |
| endchoice # LPS22HH_TRIGGER_MODE |
| |
| config LPS22HH_TRIGGER |
| bool |
| |
| config LPS22HH_THREAD_PRIORITY |
| int "Thread priority" |
| depends on LPS22HH_TRIGGER_OWN_THREAD |
| default 10 |
| help |
| Priority of thread used by the driver to handle interrupts. |
| |
| config LPS22HH_THREAD_STACK_SIZE |
| int "Thread stack size" |
| depends on LPS22HH_TRIGGER_OWN_THREAD |
| default 1024 |
| help |
| Stack size of thread used by the driver to handle interrupts. |
| |
| endif # LPS22HH |
