drivers: usb_dc_mcux: Use CONFIG_USB_DC_NXP_LPCIP3511 define
Use CONFIG_USB_DC_NXP_LPCIP3511 instead of FSL_FEATURE_USB_USB_RAM
as the behaviour variation is based on the SDK driver used and not
if the SoC has a dedicated USB SRAM.
Signed-off-by: Mahesh Mahadevan <mahesh.mahadevan@nxp.com>
diff --git a/drivers/usb/device/usb_dc_mcux.c b/drivers/usb/device/usb_dc_mcux.c
index f0040ac..c2367ef 100644
--- a/drivers/usb/device/usb_dc_mcux.c
+++ b/drivers/usb/device/usb_dc_mcux.c
@@ -73,7 +73,7 @@
/* We do not need a buffer for the write side on platforms that have USB RAM.
* The SDK driver will copy the data buffer to be sent to USB RAM.
*/
-#ifdef FSL_FEATURE_USBHSD_USB_RAM_BASE_ADDRESS
+#ifdef CONFIG_USB_DC_NXP_LPCIP3511
#define EP_BUF_NUMOF_BLOCKS (NUM_OF_EP_MAX / 2)
#else
#define EP_BUF_NUMOF_BLOCKS NUM_OF_EP_MAX
@@ -275,7 +275,7 @@
LOG_WRN("Failed to un-initialize endpoint (status=%d)", (int)status);
}
-#ifdef FSL_FEATURE_USBHSD_USB_RAM_BASE_ADDRESS
+#ifdef CONFIG_USB_DC_NXP_LPCIP3511
/* Allocate buffers used during read operation */
if (USB_EP_DIR_IS_OUT(cfg->ep_addr)) {
#endif
@@ -294,7 +294,7 @@
}
memset(block->data, 0, cfg->ep_mps);
-#ifdef FSL_FEATURE_USBHSD_USB_RAM_BASE_ADDRESS
+#ifdef CONFIG_USB_DC_NXP_LPCIP3511
}
#endif
@@ -520,7 +520,7 @@
* as the SDK driver will copy the data into USB RAM,
* if available.
*/
-#ifndef FSL_FEATURE_USBHSD_USB_RAM_BASE_ADDRESS
+#ifndef CONFIG_USB_DC_NXP_LPCIP3511
buffer = (uint8_t *)dev_state.eps[ep_abs_idx].block.data;
if (data_len > dev_state.eps[ep_abs_idx].ep_mps) {
