blob: 7132083c109abe5e2261146199a5ae322f57418b [file] [log] [blame]
#
# SPDX-License-Identifier: Apache-2.0
#
# Copyright 2023 NXP
#
if (CONFIG_DISPLAY)
message(WARNING "
CONFIG_DISPLAY: Running this firmware on a board without a display may damage the board
")
endif()
if(CONFIG_NXP_IMX_RT_BOOT_HEADER)
zephyr_library()
if(CONFIG_BOARD_MIMXRT1062_FMURT6)
# No flash configuration block exists for the RT1060 with HyperFlash in
# the SDK, but we can reuse the block for the RT1050 as FMURT6 also uses
# the same HyperFlash chip
set(FLASH_CONF evkbimxrt1050_flexspi_nor_config.c)
set(BOARD_NAME evkbimxrt1050)
endif()
set(RT1062_BOARD_DIR
"${ZEPHYR_HAL_NXP_MODULE_DIR}/mcux/mcux-sdk/boards/${BOARD_NAME}")
if(CONFIG_BOOT_FLEXSPI_NOR)
# Include flash configuration block for RT1050 EVK from NXP's HAL.
# This configuration block may need modification if another flash chip is
# used on your custom board. See NXP AN12238 for more information.
zephyr_compile_definitions(XIP_BOOT_HEADER_ENABLE=1)
zephyr_compile_definitions(BOARD_FLASH_SIZE=CONFIG_FLASH_SIZE*1024)
zephyr_library_sources(${RT1062_BOARD_DIR}/xip/${FLASH_CONF})
zephyr_library_include_directories(${RT1062_BOARD_DIR}/xip)
endif()
if(CONFIG_DEVICE_CONFIGURATION_DATA)
# Include device configuration data block for RT1050 EVK from NXP's HAL.
# This configuration block may need modification if another SDRAM chip
# is used on your custom board.
zephyr_compile_definitions(XIP_BOOT_HEADER_DCD_ENABLE=1)
zephyr_library_sources(${RT1062_BOARD_DIR}/dcd.c)
endif()
endif()
if(CONFIG_MCUX_GPT_TIMER)
message(WARNING "You appear to be using the GPT hardware timer. "
"This timer will enable lower power modes, but at the cost of reduced "
"hardware timer resolution")
endif()