drivers/pinmux/Kconfig

# Kconfig - Pinmux configuration options

#
# Copyright (c) 2015 Intel Corporation
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
#     http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
#

#
# PinMux options
#
menuconfig PINMUX
	bool "Enable board pinmux driver"
	default n

if PINMUX

source "drivers/pinmux/dev/Kconfig"

config PINMUX_NAME
	string "Pinmux driver name"
	depends on PINMUX
	default "PINMUX"
	help
	The name of the pinmux driver.

config PINMUX_INIT_PRIORITY
	int
	prompt "Init priority"
	default 45
	depends on PINMUX
	help
	  Pinmux driver initialization priority.
	  Pinmux driver almost certainly should be initialized before the
	  rest of hardware devices (which may need specific pins already
	  configured for them), and usually after generic GPIO drivers.
	  Thus, its priority should be between KERNEL_INIT_PRIORITY_DEFAULT
	  and KERNEL_INIT_PRIORITY_DEVICE. There are exceptions to this
	  rule for particular boards. Don't change this value unless you
	  know what you are doing.

config PINMUX_K64
	bool "Freescale K64-based Pin multiplexer driver"
	depends on SOC_MK64F12
	default n
	help
	Enable driver for Freescale K64-based Pin multiplexer.

source "drivers/pinmux/Kconfig.stm32"

source "drivers/pinmux/Kconfig.beetle"

endif # PINMUX