| # nRF9160 DK NRF9160 board configuration |
| |
| # Copyright (c) 2018-2020 Nordic Semiconductor ASA |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| if BOARD_NRF9160DK_NRF9160 || BOARD_NRF9160DK_NRF9160_NS |
| |
| # For the secure version of the board the firmware is linked at the beginning |
| # of the flash, or into the code-partition defined in DT if it is intended to |
| # be loaded by MCUboot. If the secure firmware is to be combined with a non- |
| # secure image (TRUSTED_EXECUTION_SECURE=y), the secure FW image shall always |
| # be restricted to the size of its code partition. |
| # For the non-secure version of the board, the firmware |
| # must be linked into the code-partition (non-secure) defined in DT, regardless. |
| # Apply this configuration below by setting the Kconfig symbols used by |
| # the linker according to the information extracted from DT partitions. |
| |
| # Workaround for not being able to have commas in macro arguments |
| DT_CHOSEN_Z_CODE_PARTITION := zephyr,code-partition |
| |
| config FLASH_LOAD_SIZE |
| default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION)) |
| depends on BOARD_NRF9160DK_NRF9160 && TRUSTED_EXECUTION_SECURE |
| |
| if BOARD_NRF9160DK_NRF9160_NS |
| |
| config FLASH_LOAD_OFFSET |
| default $(dt_chosen_reg_addr_hex,$(DT_CHOSEN_Z_CODE_PARTITION)) |
| |
| config FLASH_LOAD_SIZE |
| default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION)) |
| |
| endif # BOARD_NRF9160DK_NRF9160_NS |
| |
| config BT_HCI_VS |
| default y if BT |
| |
| config BT_WAIT_NOP |
| default BT && $(dt_nodelabel_enabled,nrf52840_reset) |
| |
| config I2C |
| default $(dt_compat_on_bus,$(DT_COMPAT_NXP_PCAL6408A),i2c) |
| |
| endif # BOARD_NRF9160DK_NRF9160 || BOARD_NRF9160DK_NRF9160_NS |
| |
| if BOARD_NRF9160DK_NRF52840 |
| |
| config BT_CTLR |
| default BT |
| |
| config BT_WAIT_NOP |
| default BT && $(dt_nodelabel_enabled,reset_input) |
| |
| endif # BOARD_NRF9160DK_NRF52840 |
