| .. zephyr:board:: qemu_kvm_arm64 |
| |
| Overview |
| ******** |
| |
| This board configuration will use QEMU to run a KVM guest on an AArch64 |
| host. |
| |
| This configuration provides support for an AArch64 Cortex-A CPU and these |
| devices: |
| |
| * GICv3 interrupt controller |
| * ARM architected timer |
| * PL011 UART controller |
| |
| Hardware |
| ******** |
| Supported Features |
| ================== |
| |
| The following hardware features are supported: |
| |
| +--------------+------------+----------------------+ |
| | Interface | Controller | Driver/Component | |
| +==============+============+======================+ |
| | GIC | on-chip | interrupt controller | |
| +--------------+------------+----------------------+ |
| | PL011 UART | on-chip | serial port | |
| +--------------+------------+----------------------+ |
| | ARM TIMER | on-chip | system clock | |
| +--------------+------------+----------------------+ |
| |
| The kernel currently does not support other hardware features on this platform. |
| |
| Devices |
| ======== |
| System Clock |
| ------------ |
| |
| This board configuration uses the host system clock frequency. |
| |
| Serial Port |
| ----------- |
| |
| This board configuration uses a single serial communication channel with the |
| CPU's UART0. |
| |
| Programming and Debugging |
| ************************* |
| |
| Refer to the qemu_cortex_a53 board instructions for this part. |
| |
| Debugging |
| ========= |
| |
| Refer to the detailed overview about :ref:`application_debugging`. |
