| # Copyright (c) 2018 STMicroelectronics |
| # Copyright (c) 2024 SILA Embedded Solutions GmbH |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| include: sensor-device.yaml |
| |
| properties: |
| int1-gpios: |
| type: phandle-array |
| description: | |
| INT_1 pin |
| |
| This pin defaults to active high when produced by the sensor. The property value should ensure |
| the flags properly describe the signal that is presented to the driver. |
| |
| int2-gpios: |
| type: phandle-array |
| description: | |
| INT_2 pin |
| |
| This pin defaults to active high when produced by the sensor. The property value should ensure |
| the flags properly describe the signal that is presented to the driver. |
| |
| drdy-int-pad: |
| type: int |
| enum: [1, 2] |
| description: | |
| Select DRDY pin number (1 or 2). |
| |
| This number represents which of the two interrupt pins (INT_1 or INT_2), if any, the DRDY |
| interrupt should be generated from. If this property is not specified, no data ready |
| interrupts can be registered. |
| |
| - 1 # drdy is generated on INT1 |
| - 2 # drdy is generated on INT2 |
| |
| threshold-int-pad: |
| type: int |
| enum: [1, 2] |
| description: | |
| Select threshold interrupt pin number (1 or 2). |
| |
| This number represents which of the two interrupt pins (INT_1 or INT_2), if any, the threshold |
| interrupt should be generated from. If this property is not specified, no threshold interrupts |
| can be registered. |
| |
| - 1 # threshold interrupt is generated on INT1 |
| - 2 # threshold interrupt is generated on INT2 |
| |
| range: |
| type: int |
| default: 2 |
| description: | |
| Range in g. Default is power-up configuration. |
| |
| - 16 # 16g (1.952 mg/LSB) |
| - 8 # 8g (0.976 mg/LSB) |
| - 4 # 4g (0.488 mg/LSB) |
| - 2 # 2g (0.244 mg/LSB) |
| |
| enum: [16, 8, 4, 2] |
