| .. _ene_kb1200_evb: |
| |
| ENE KB1200_EVB |
| ############## |
| |
| Overview |
| ******** |
| |
| The KB1200_EVB kit is a development platform to evaluate the |
| ENE KB1200 series microcontrollers. This board needs to be mated with |
| part number KB1200. |
| |
| |
| Hardware |
| ******** |
| |
| - ARM Cortex-M4F Processor |
| - 512KB Flash and 320KB RAM |
| - ADC & GPIO headers |
| - SER1, SER2 and SER3 |
| - FAN PWM interface |
| - ENE Debug interface |
| |
| Supported Features |
| ================== |
| |
| The following features are supported: |
| |
| +-----------+------------+-------------------------------------+ |
| | Interface | Controller | Driver/Component | |
| +===========+============+=====================================+ |
| | NVIC | on-chip | nested vector interrupt controller | |
| +-----------+------------+-------------------------------------+ |
| | ADC | on-chip | adc controller | |
| +-----------+------------+-------------------------------------+ |
| | CLOCK | on-chip | reset and clock control | |
| +-----------+------------+-------------------------------------+ |
| | GPIO | on-chip | gpio | |
| +-----------+------------+-------------------------------------+ |
| | I2C | on-chip | i2c port/controller | |
| +-----------+------------+-------------------------------------+ |
| | PINMUX | on-chip | pinmux | |
| +-----------+------------+-------------------------------------+ |
| | PMU | on-chip | power management | |
| +-----------+------------+-------------------------------------+ |
| | PSL | on-chip | power switch logic | |
| +-----------+------------+-------------------------------------+ |
| | PWM | on-chip | pulse width modulator | |
| +-----------+------------+-------------------------------------+ |
| | TACH | on-chip | tachometer sensor | |
| +-----------+------------+-------------------------------------+ |
| | SER | on-chip | serial port-polling; | |
| | | | serial port-interrupt | |
| +-----------+------------+-------------------------------------+ |
| | WDT | on-chip | watchdog | |
| +-----------+------------+-------------------------------------+ |
| |
| Other hardware features are not currently supported by Zephyr (at the moment) |
| |
| System Clock |
| ============ |
| |
| The KB1200 MCU is configured to use the 96Mhz internal oscillator with the |
| on-chip DPLL to generate a resulting EC clock rate of 96MHz/48MHz/24MHz/12MHz. |
| See Processor clock control register (refer 5.1 General Configuration) |
| |
| Programming and Debugging |
| ************************* |
| |
| Flashing |
| ======== |
| |
| If the correct headers are installed, this board supports SWD Debug Interface. |
| |
| To flash with SWD, install the drivers for your programmer, for example: |
| SEGGER J-link's drivers are at https://www.segger.com/downloads/jlink/ |
| |
| Debugging |
| ========= |
| |
| Use SWD with a J-Link |
| |
| References |
| ========== |
| |
| .. target-notes:: |
