| # ENS210 Digital Temperature and Humidity sensor configuration options |
| |
| # Copyright (c) 2018 Alexander Wachter. |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| menuconfig ENS210 |
| bool "ENS210 Digital Temperature and Humidity sensor" |
| default y |
| depends on DT_HAS_AMS_ENS210_ENABLED |
| select I2C |
| help |
| Enable driver for ENS210 Digital Temperature and Humidity sensor. |
| if ENS210 |
| |
| choice |
| prompt "Temperature measurement mode" |
| default ENS210_TEMPERATURE_CONTINUOUS |
| help |
| Enable/disable temperature measurements and set measurement mode. |
| config ENS210_TEMPERATURE_OFF |
| bool "Disable temperature measurements" |
| config ENS210_TEMPERATURE_SINGLE |
| bool "Temperature measurements in single shot mode" |
| config ENS210_TEMPERATURE_CONTINUOUS |
| bool "Temperature measurements in continuous mode" |
| endchoice |
| |
| choice |
| prompt "Humidity measurement mode" |
| default ENS210_HUMIDITY_CONTINUOUS |
| help |
| Enable/disable relative humidity measurements and set measurement mode. |
| config ENS210_HUMIDITY_OFF |
| bool "Disable relative humidity measurements" |
| config ENS210_HUMIDITY_SINGLE |
| bool "Relative humidity measurements in single shot mode" |
| config ENS210_HUMIDITY_CONTINUOUS |
| bool "Relative humidity measurements in continuous mode" |
| endchoice |
| |
| config ENS210_CRC_CHECK |
| bool "CRC Check" |
| default y |
| help |
| Check the crc value after data reading. |
| |
| config ENS210_MAX_STAT_RETRIES |
| int "Number of status read retries" |
| default 4 |
| help |
| Number of retries when status reading failed or device not ready. |
| |
| config ENS210_MAX_READ_RETRIES |
| int "Number of value reading retries" |
| default 4 |
| help |
| Number of retries when value reading failed, value not valid |
| or crc not ok. |
| |
| endif # ENS210 |
