| macro(set_conf_file) |
| if(PROFILER) |
| set(CONF_FILE prj_${BOARD}_prof.conf) |
| else() |
| set(CONF_FILE prj_${BOARD}.conf) |
| endif() |
| endmacro() |
| |
| include($ENV{ZEPHYR_BASE}/cmake/app/boilerplate.cmake NO_POLICY_SCOPE) |
| project(NONE) |
| |
| target_sources( |
| app PRIVATE |
| src/shell_utils.c |
| src/zperf_session.c |
| src/zperf_shell.c |
| ) |
| target_sources_ifdef( |
| CONFIG_NET_UDP |
| app PRIVATE |
| src/zperf_udp_receiver.c |
| src/zperf_udp_uploader.c |
| ) |
| target_sources_ifdef( |
| CONFIG_NET_TCP |
| app PRIVATE |
| src/zperf_tcp_receiver.c |
| src/zperf_tcp_uploader.c |
| ) |
| |
| target_compile_definitions_ifdef( |
| PROFILER |
| app PRIVATE |
| PROFILER |
| ) |
| |
| target_include_directories(app PRIVATE |
| $ENV{ZEPHYR_BASE}/subsys/net/ip |
| $ENV{ZEPHYR_BASE}/samples/task_profiler/profiler/src |
| ) |
| |
| if(PROFILER) |
| assert(0 "PROFILER is not supported yet") |
| # KBuild did this, but this did not work, not sure why. |
| # export PROFILER_NO_SHELL_REGISTER=1 |
| # obj-y += ../../../task_profiler/profiler/ |
| endif() |
