boards/nxp/lpcxpresso55s69/Kconfig.defconfig

# Copyright 2019,2024 NXP
# SPDX-License-Identifier: Apache-2.0

if BOARD_LPCXPRESSO55S69

if FXOS8700

choice FXOS8700_MODE
	default FXOS8700_MODE_ACCEL
endchoice

config FXOS8700_DRDY_INT1
	default y
	depends on FXOS8700_TRIGGER

endif # FXOS8700

# For the secure version of the board the firmware is linked at the beginning
# of the flash, or into the code-partition defined in DT if it is intended to
# be loaded by MCUboot. If the secure firmware is to be combined with a non-
# secure image (TRUSTED_EXECUTION_SECURE=y), the secure FW image shall always
# be restricted to the size of its code partition.
# For the non-secure version of the board, the firmware
# must be linked into the code-partition (non-secure) defined in DT, regardless.
# Apply this configuration below by setting the Kconfig symbols used by
# the linker according to the information extracted from DT partitions.

# Workaround for not being able to have commas in macro arguments
DT_CHOSEN_Z_CODE_PARTITION := zephyr,code-partition

config FLASH_LOAD_SIZE
	default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION))
	depends on BOARD_LPCXPRESSO55S69_LPC55S69_CPU0 && TRUSTED_EXECUTION_SECURE

if TRUSTED_EXECUTION_NONSECURE || BOARD_LPCXPRESSO55S69_LPC55S69_CPU1

config FLASH_LOAD_OFFSET
	default 0x50000 if (!TFM_BL2 && BUILD_WITH_TFM)
	default $(dt_chosen_reg_addr_hex,$(DT_CHOSEN_Z_CODE_PARTITION))

config FLASH_LOAD_SIZE
	default 0x40000 if (!TFM_BL2 && BUILD_WITH_TFM)
	default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION))

endif # TRUSTED_EXECUTION_NONSECURE || BOARD_LPCXPRESSO55S69_LPC55S69_CPU1

choice TFM_PROFILE_TYPE
	depends on BUILD_WITH_TFM
	default TFM_PROFILE_TYPE_MEDIUM
endchoice

if BOOTLOADER_MCUBOOT
choice MCUBOOT_BOOTLOADER_MODE
	# Board only supports MCUBoot via "upgrade only" method:
	default MCUBOOT_BOOTLOADER_MODE_OVERWRITE_ONLY
endchoice
endif #BOOTLOADER_MCUBOOT

endif # BOARD_LPCXPRESSO55S69