| # Note: Using OpenOCD using nucloe_wba52cg requires using STMicroelectronics |
| # openocd fork. See board documentation for more information |
| |
| source [find interface/stlink-dap.cfg] |
| |
| set WORKAREASIZE 0x8000 |
| |
| transport select "dapdirect_swd" |
| |
| # Enable debug when in low power modes |
| set ENABLE_LOW_POWER 1 |
| |
| # Stop Watchdog counters when halt |
| set STOP_WATCHDOG 1 |
| |
| # STlink Debug clock frequency |
| set CLOCK_FREQ 8000 |
| |
| # Reset configuration |
| # use hardware reset, connect under reset |
| # connect_assert_srst needed if low power mode application running (WFI...) |
| reset_config srst_only srst_nogate |
| |
| source [find target/stm32wbax.cfg] |