| /* |
| * Copyright (c) 2021 Jimmy Johnson <catch22@fastmail.net> |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| #ifndef ZEPHYR_DRIVERS_SENSOR_TMP108_TMP108_H_ |
| #define ZEPHYR_DRIVERS_SENSOR_TMP108_TMP108_H_ |
| |
| #include <stdint.h> |
| |
| #include <zephyr/drivers/sensor.h> |
| #include <zephyr/drivers/gpio.h> |
| #include <zephyr/drivers/sensor/tmp108.h> |
| |
| #define TI_TMP108_REG_TEMP 0x00 /** Temperature register */ |
| #define TI_TMP108_REG_CONF 0x01 /** Configuration register */ |
| #define TI_TMP108_REG_LOW_LIMIT 0x02 /** Low alert set register */ |
| #define TI_TMP108_REG_HIGH_LIMIT 0x03 /** High alert set register */ |
| |
| |
| #define TI_TMP108_CONF_M0 0x0100 /** Mode 1 configuration bit */ |
| #define TI_TMP108_CONF_M1 0x0200 /** Mode 2 configuration bit */ |
| #define TI_TMP108_CONF_CR0 0x2000 /** Conversion rate 1 configuration bit */ |
| #define TI_TMP108_CONF_CR1 0x4000 /** Conversion rate 2 configuration bit */ |
| #define TI_TMP108_CONF_POL 0x0080 /** Alert pin Polarity configuration bit */ |
| #define TI_TMP108_CONF_TM 0x0400 /** Thermostat mode setting bit */ |
| #define TI_TMP108_CONF_HYS1 0x0020 /** Temperature hysteresis config 1 bit */ |
| #define TI_TMP108_CONF_HYS0 0x0010 /** Temperature hysteresis config 2 bit */ |
| #define TI_TMP108_CONF_WFH OVER_TEMP_MASK |
| #define TI_TMP108_CONF_WFL UNDER_TEMP_MASK |
| |
| #define TI_TMP108_MODE_SHUTDOWN 0 |
| #define TI_TMP108_MODE_ONE_SHOT TI_TMP108_CONF_M0 |
| #define TI_TMP108_MODE_CONTINUOUS TI_TMP108_CONF_M1 |
| #define TI_TMP108_MODE_MASK ~(TI_TMP108_CONF_M1 | TI_TMP108_CONF_M1) |
| |
| #define TI_TMP108_FREQ_4_SECS 0 |
| #define TI_TMP108_FREQ_1_HZ TI_TMP108_CONF_CR0 |
| #define TI_TMP108_FREQ_4_HZ TI_TMP108_CONF_CR1 |
| #define TI_TMP108_FREQ_16_HZ (TI_TMP108_CONF_CR1 | TI_TMP108_CONF_CR0) |
| #define TI_TMP108_FREQ_MASK ~(TI_TMP108_CONF_M1 | TI_TMP108_CONF_M1) |
| |
| #define TI_TMP108_CONF_POL_LOW 0 |
| #define TI_TMP108_CONF_POL_HIGH TI_TMP108_CONF_POL |
| #define TI_TMP108_CONF_POL_MASK ~(TI_TMP108_CONF_POL) |
| |
| #define TI_TMP108_CONF_TM_CMP 0 |
| #define TI_TMP108_CONF_TM_INT TI_TMP108_CONF_TM |
| #define TI_TMP108_CONF_TM_MASK ~(TI_TMP108_CONF_TM) |
| |
| #define TI_TMP108_HYSTER_0_C 0 |
| #define TI_TMP108_HYSTER_1_C TI_TMP108_CONF_HYS0 |
| #define TI_TMP108_HYSTER_2_C TI_TMP108_CONF_HYS1 |
| #define TI_TMP108_HYSTER_4_C (TI_TMP108_CONF_HYS1 | TI_TMP108_CONF_HYS0) |
| #define TI_TMP108_HYSTER_MASK ~(TI_TMP108_CONF_HYS1 | TI_TMP108_CONF_HYS0) |
| |
| struct tmp108_data { |
| const struct device *tmp108_dev; |
| |
| uint16_t sample; |
| |
| bool one_shot_mode; |
| |
| struct k_work_delayable scheduled_work; |
| |
| struct sensor_trigger temp_alert_trigger; |
| sensor_trigger_handler_t temp_alert_handler; |
| |
| sensor_trigger_handler_t data_ready_handler; |
| struct sensor_trigger data_ready_trigger; |
| |
| struct gpio_callback temp_alert_gpio_cb; |
| }; |
| |
| int tmp_108_trigger_set(const struct device *dev, |
| const struct sensor_trigger *trig, |
| sensor_trigger_handler_t handler); |
| |
| int tmp108_reg_read(const struct device *dev, uint8_t reg, uint16_t *val); |
| |
| int ti_tmp108_read_temp(const struct device *dev); |
| void tmp108_trigger_handle_one_shot(struct k_work *work); |
| void tmp108_trigger_handle_alert(const struct device *port, |
| struct gpio_callback *cb, |
| gpio_port_pins_t pins); |
| |
| #endif /* ZEPHYR_DRIVERS_SENSOR_TMP108_TMP108_H_ */ |