| /* |
| * Copyright (c) 2018 Christian Taedcke |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| #ifndef __INC_BOARD_H |
| #define __INC_BOARD_H |
| |
| #include <soc.h> |
| |
| /* Push button PB0 */ |
| #define PB0_GPIO_NAME CONFIG_GPIO_GECKO_PORTF_NAME |
| #define PB0_GPIO_PIN 6 |
| |
| /* Push button PB1 */ |
| #define PB1_GPIO_NAME CONFIG_GPIO_GECKO_PORTF_NAME |
| #define PB1_GPIO_PIN 7 |
| |
| /* LED 0 */ |
| #define LED0_GPIO_NAME CONFIG_GPIO_GECKO_PORTF_NAME |
| #define LED0_GPIO_PORT LED0_GPIO_NAME |
| #define LED0_GPIO_PIN 4 |
| |
| /* LED 1 */ |
| #define LED1_GPIO_NAME CONFIG_GPIO_GECKO_PORTF_NAME |
| #define LED1_GPIO_PIN 5 |
| |
| /* Push button switch 0. There is no physical switch on the board with this |
| * name, so create an alias to SW3 to make the basic button sample work. |
| */ |
| #define SW0_GPIO_NAME PB0_GPIO_NAME |
| #define SW0_GPIO_PIN PB0_GPIO_PIN |
| |
| /* This pin is used to enable the serial port using the board controller */ |
| #define BC_ENABLE_GPIO_NAME CONFIG_GPIO_GECKO_PORTA_NAME |
| #define BC_ENABLE_GPIO_PIN 5 |
| |
| #endif /* __INC_BOARD_H */ |
