| #!/bin/sh |
| # |
| # Copyright (c) 2018 Intel Corporation |
| # |
| # Licensed under the Apache License, Version 2.0 (the "License"); |
| # you may not use this file except in compliance with the License. |
| # You may obtain a copy of the License at |
| # |
| # http://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, software |
| # distributed under the License is distributed on an "AS IS" BASIS, |
| # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| # See the License for the specific language governing permissions and |
| # limitations under the License. |
| |
| # This script is called by native-posix board when TAP network interface |
| # is taken up by Zephyr. The script should setup the host system so that |
| # connectivity will work with Zephyr. |
| |
| while [ $# -gt 0 ]; do |
| case "$1" in |
| -f|--file) |
| CONF_FILE="$2" |
| shift |
| shift;; |
| -i|--interface) |
| # Only first -i option is taken into account. This way |
| # the driver added -i option is ignored if user has specified |
| # the -i option to host setup script command. |
| if [ -z "$IFACE" ]; then |
| IFACE="$2" |
| fi |
| shift |
| shift;; |
| *) |
| shift;; |
| esac |
| done |
| |
| if [ `id -u` != 0 ]; then |
| echo "Warning: This script will need admin rights to setup \ |
| network interface!" |
| fi |
| |
| if [ -z "$IFACE" ]; then |
| IFACE="zeth" |
| fi |
| |
| if [ -z "$CONF_FILE" ]; then |
| DIR=`dirname $0` |
| CONF_FILE="$DIR/net_setup_host.conf" |
| fi |
| |
| if [ -f "$CONF_FILE" ]; then |
| . $CONF_FILE |
| else |
| echo "Warning: config file $CONF_FILE does not exist!" |
| fi |
| |
| ip link set dev $IFACE up |
| |
| if [ ! -z "$HWADDR" ]; then |
| ip link set dev $IFACE address $HWADDR |
| fi |
| |
| if [ ! -z "$IPV6_ADDR_1" ]; then |
| ip -6 address add $IPV6_ADDR_1 dev $IFACE |
| fi |
| |
| if [ ! -z "$IPV6_ROUTE_1" ]; then |
| ip -6 route add $IPV6_ROUTE_1 dev $IFACE |
| fi |
| |
| if [ ! -z "$IPV4_ADDR_1" ]; then |
| ip address add $IPV4_ADDR_1 dev $IFACE |
| fi |
| |
| if [ ! -z "$IPV4_ROUTE_1" ]; then |
| ip route add $IPV4_ROUTE_1 dev $IFACE |
| fi |