| # Kconfig - AMG88XX infrared thermopile sensor configuration options |
| |
| # |
| # Copyright (c) 2017 Phytec Messtechnik GmbH |
| # |
| # SPDX-License-Identifier: Apache-2.0 |
| # |
| |
| menuconfig AMG88XX |
| bool "AMG88XX Infrared Thermopile Sensor" |
| depends on I2C |
| help |
| Enable driver for AMG88XX infrared thermopile sensor. |
| |
| if AMG88XX |
| |
| config AMG88XX_NAME |
| string "Driver name" |
| default "AMG88XX" |
| help |
| Device name identifying the AMG88XX sensor. |
| |
| config AMG88XX_I2C_ADDR |
| hex "I2C address for AMG88XX Sensor" |
| default "0x68" |
| range 0x68 0x69 |
| help |
| I2C address of the AMG88XX sensor. |
| |
| 0x68: AD-SELECT connected GND |
| 0x69: AD-SELECT connected VDD |
| |
| config AMG88XX_I2C_MASTER_DEV_NAME |
| string "I2C master where AMG88XX is connected" |
| default "I2C_0" |
| help |
| The I2C master device's name where the AMG88XX sensor is connected. |
| |
| choice |
| prompt "Trigger mode" |
| default AMG88XX_TRIGGER_NONE |
| help |
| Specify the type of triggering used by the driver. |
| |
| config AMG88XX_TRIGGER_NONE |
| bool "No trigger" |
| |
| config AMG88XX_TRIGGER_GLOBAL_THREAD |
| bool "Use global thread" |
| depends on GPIO |
| select AMG88XX_TRIGGER |
| |
| config AMG88XX_TRIGGER_OWN_THREAD |
| bool "Use own thread" |
| depends on GPIO |
| select AMG88XX_TRIGGER |
| |
| endchoice |
| |
| config AMG88XX_TRIGGER |
| bool |
| |
| config AMG88XX_GPIO_DEV_NAME |
| string "GPIO device" |
| default "GPIO_0" |
| depends on AMG88XX_TRIGGER |
| help |
| The GPIO device's name where the AMG88XX interrupt (alert) pin is |
| connected. |
| |
| config AMG88XX_GPIO_PIN_NUM |
| int "Interrupt GPIO pin number" |
| default 0 |
| depends on AMG88XX_TRIGGER |
| help |
| The GPIO pin number receiving the interrupt signal from the |
| AMG88XX sensor. |
| |
| config AMG88XX_THREAD_PRIORITY |
| int "Thread priority" |
| depends on AMG88XX_TRIGGER_OWN_THREAD |
| default 10 |
| help |
| Priority of thread used by the driver to handle interrupts. |
| |
| config AMG88XX_THREAD_STACK_SIZE |
| int "Thread stack size" |
| depends on AMG88XX_TRIGGER_OWN_THREAD |
| default 1024 |
| help |
| Stack size of thread used by the driver to handle interrupts. |
| |
| endif #if AMG88XX |
