| .. zephyr:board:: nrf54l20pdk |
| |
| Overview |
| ******** |
| |
| .. note:: |
| |
| All software for the nRF54L20 SoC is experimental and hardware availability |
| is restricted to the participants in the limited sampling program. |
| |
| The nRF54L20 Preview Development Kit hardware provides |
| support for the Nordic Semiconductor nRF54L20 Arm Cortex-M33 CPU and |
| the following devices: |
| |
| * CLOCK |
| * RRAM |
| * :abbr:`GPIO (General Purpose Input Output)` |
| * :abbr:`GRTC (Global real-time counter)` |
| * :abbr:`NVIC (Nested Vectored Interrupt Controller)` |
| * :abbr:`UARTE (Universal asynchronous receiver-transmitter)` |
| |
| Hardware |
| ******** |
| |
| nRF54L20 PDK has two crystal oscillators: |
| |
| * High-frequency 32 MHz crystal oscillator (HFXO) |
| * Low-frequency 32.768 kHz crystal oscillator (LFXO) |
| |
| The crystal oscillators can be configured to use either |
| internal or external capacitors. |
| |
| Supported Features |
| ================== |
| |
| .. zephyr:board-supported-hw:: |
| |
| Programming and Debugging |
| ************************* |
| |
| .. zephyr:board-supported-runners:: |
| |
| Applications for the ``nrf54l20pdk/nrf54l20/cpuapp`` board target can be |
| built, flashed, and debugged in the usual way. See |
| :ref:`build_an_application` and :ref:`application_run` for more details on |
| building and running. |
| |
| Applications for the ``nrf54l20pdk/nrf54l20/cpuflpr`` board target need |
| to be built using sysbuild to include the ``vpr_launcher`` image for the application core. |
| |
| Enter the following command to compile ``hello_world`` for the FLPR core:: |
| west build -p -b nrf54l20pdk/nrf54l20/cpuflpr --sysbuild |
| |
| Flashing |
| ======== |
| |
| As an example, this section shows how to build and flash the :zephyr:code-sample:`hello_world` |
| application. |
| |
| Follow the instructions in the :ref:`nordic_segger` page to install |
| and configure all the necessary software. Further information can be |
| found in :ref:`nordic_segger_flashing`. |
| |
| To build and program the sample to the nRF54L20 PDK, complete the following steps: |
| |
| First, connect the nRF54L20 PDK to you computer using the IMCU USB port on the PDK. |
| Next, build the sample by running the following command: |
| |
| .. zephyr-app-commands:: |
| :zephyr-app: samples/hello_world |
| :board: nrf54l20pdk/nrf54l20/cpuapp |
| :goals: build flash |
| |
| Testing the LEDs and buttons in the nRF54L20 PDK |
| ************************************************ |
| |
| Test the nRF54L20 PDK with a :zephyr:code-sample:`blinky` sample. |
