drivers/flash/Kconfig.nxp_s32

# Copyright 2023 NXP
# SPDX-License-Identifier: Apache-2.0

config FLASH_NXP_S32_QSPI_NOR
	bool "NXP S32 QSPI NOR driver"
	default y
	depends on DT_HAS_NXP_S32_QSPI_NOR_ENABLED
	select MEMC
	select FLASH_HAS_PAGE_LAYOUT
	select FLASH_HAS_DRIVER_ENABLED
	select FLASH_JESD216
	help
	  Enable the Flash driver for a NOR Serial Flash Memory device connected
	  to an NXP S32 QSPI bus.

if FLASH_NXP_S32_QSPI_NOR

config FLASH_NXP_S32_QSPI_NOR_SFDP_RUNTIME
	bool "Read flash parameters at runtime"
	help
	  Read flash device characteristics from the device at runtime.
	  This option should provide functionality for all supported
	  JESD216-compatible devices, with the following notes:
	  - Quad Enable Requirements bitfield (DW15) must be present in the SFDP
	    tables to configure Quad mode. Otherwise it defaults to Dual or
	    Single mode as supported by the device.
	  - Soft Reset bitfield (DW16) must be present in the SFDP tables to
	    automatically reset the device at initialization time.
	  - 0-X-X mode discovery not yet implemented by the HAL.

	  If not selected, the driver uses a fixed configuration assuming 256 By
	  page size and 4 KiBy, 32 KiBy and 64 KiBy erase instructions. The
	  device size and jedec-id properties must be set in devicetree node.

config FLASH_NXP_S32_QSPI_VERIFY_ERASE
	bool "Verify memory after erased"
	help
	  Verify contents of memory after erased.

config FLASH_NXP_S32_QSPI_VERIFY_WRITE
	bool "Verify memory after written"
	help
	  Verify contents of memory after written.

config FLASH_NXP_S32_QSPI_LAYOUT_PAGE_SIZE
	int "Page size to use for FLASH_LAYOUT feature"
	default 4096
	help
	  When CONFIG_FLASH_PAGE_LAYOUT is used this driver will support that API.
	  By default the page size corresponds to the sector size (4096) for a NOR
	  flash memory. Other options may include the 32K-byte erase size (32768),
	  the block size (65536), or any non-zero multiple of the sector size.

endif # FLASH_NXP_S32_QSPI_NOR